What am I doing wrong or what do I need to do to resolve it?
NA JDM Roadster Stainless Steel Sill Covers
Moderators: timk, Stu, zombie, Andrew, -alex, miata
-
twr7cx
- Fast Driver
- Posts: 221
- Joined: Thu Aug 04, 2016 9:55 am
- Vehicle: NA6
- Location: Hobart, Tasmania, Australia
NA JDM Roadster Stainless Steel Sill Covers
I have an 89 JDM NA6 and I've just purchased a set of the stainless steel sill covers that I believe were from the JDM Eunos Roadster. When I test fitted them (I assumed the Roadster logo goes towards the vehicles rear), I find that they're not long enough to meet back to the plastic trim either side leaving a gap:
What am I doing wrong or what do I need to do to resolve it?
What am I doing wrong or what do I need to do to resolve it?
-
bruce
- Speed Racer
- Posts: 7707
- Joined: Fri Apr 25, 2003 11:00 am
- Vehicle: NA8 - Turbo
- Location: Victoria
- Contact:
Re: NA JDM Roadster Stainless Steel Sill Covers
Normal. I put in a strip of thick black draft stopper tape to fill in the gap.
-
twr7cx
- Fast Driver
- Posts: 221
- Joined: Thu Aug 04, 2016 9:55 am
- Vehicle: NA6
- Location: Hobart, Tasmania, Australia
Re: NA JDM Roadster Stainless Steel Sill Covers
bruce wrote:Normal. I put in a strip of thick black draft stopper tape to fill in the gap.
Really? Surely the JDM vehicles didn't leave the factory with a gap there! Maybe they had different trim plastics either side of them?
Return to “MX5 Body, Paint, Interior & Trim”
Who is online
Users browsing this forum: No registered users and 128 guests
