I'm looking for a workshop that can do a PPF delete and a few other little bits of fab work on an NA. It's for a research project. Pref around the south-western sydney (Hoxton/Livo) area, but can travel around sydney if required.
Any recommendations?
Fabrication workshop recommendations - Sydney
Moderators: timk, Stu, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy, zombie, Andrew, The American, Lokiel
-
PLB-389
- Learner Driver
- Posts: 11
- Joined: Fri Jan 29, 2016 2:17 pm
- Vehicle: NA6
-
NitroDann
- Forum sponsor
- Posts: 10280
- Joined: Thu Nov 05, 2009 12:10 pm
- Vehicle: NA6
- Location: Newcastle NSW
- Contact:
Re: Fabrication workshop recommendations - Sydney
Suli at purefab is pretty good.
Dann
Dann
http://www.NitroDann.com
speed wrote:If I was to do it again, I wouldn't even consider the supercharger.
-
PLB-389
- Learner Driver
- Posts: 11
- Joined: Fri Jan 29, 2016 2:17 pm
- Vehicle: NA6
Re: Fabrication workshop recommendations - Sydney
Thanks Dann,
I contacted him and he seems very knowledgeable. Seems like a bit of a wait before I can get him though but I'm sure it'll be worth it.
Peter
I contacted him and he seems very knowledgeable. Seems like a bit of a wait before I can get him though but I'm sure it'll be worth it.
Peter
-
zossy1
- Racing Driver
- Posts: 1979
- Joined: Wed Aug 18, 2010 8:48 am
- Vehicle: NA8
- Location: Southern Highlands, NSW
- Contact:
Re: Fabrication workshop recommendations - Sydney
Craig Wildridge and Jeff Hanson at Zero Tolerance Motorsport in Narellan. Their work is excellent. Get down there now to see the Silver Spud's new rear end being built - should be finished next week.
Who is online
Users browsing this forum: No registered users and 14 guests
