Could some wise person shead some light for me. Mine is a 98 NB8A with a highly modified normally aspirated engine (new).
Just run in and gave it a good run at Winton. I normally run it to 8000rpm with no issues, but because it's fairly new (1500 kms) limited it to 7500 rpm. Occassionly l was getting a slight miss at about 6500rpm with the tachometer needle bouncing. New plugs, comp ht leads, throttle body sonic cleaned, cam angle sensor and crank angle sensor standard, as is fuel pump.
Coiack failure
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
- Driver
- Posts: 97
- Joined: Mon Jan 28, 2013 5:22 pm
- Vehicle: NB8A
- Location: Leopold - 10 minutes out of Geelong VIC
-
- Speed Racer
- Posts: 3119
- Joined: Tue Mar 11, 2014 8:33 pm
- Vehicle: NA8 - Supercharged
- Location: Brisbane
Re: Coiack failure
What ECU is in it? Is it rev limiting by cutting spark?
-
- Driver
- Posts: 97
- Joined: Mon Jan 28, 2013 5:22 pm
- Vehicle: NB8A
- Location: Leopold - 10 minutes out of Geelong VIC
Re: Coilpack failure
Using a Microtech LT10s
-
- Speed Racer
- Posts: 3119
- Joined: Tue Mar 11, 2014 8:33 pm
- Vehicle: NA8 - Supercharged
- Location: Brisbane
Re: Coiack failure
I was thinking that if the ECU was cutting spark then the tacho would bounce around if the tacho is still dríven off the coilpack. If the tacho is dríven off the ECU then that's another matter.
- bruce
- Speed Racer
- Posts: 7706
- Joined: Fri Apr 25, 2003 11:00 am
- Vehicle: NA8 - Turbo
- Location: Victoria
- Contact:
Re: Coiack failure
When I had problems with my coiack, my doctor said I should eat more fibre.
- NitroDann
- Forum sponsor
- Posts: 10280
- Joined: Thu Nov 05, 2009 12:10 pm
- Vehicle: NA6
- Location: Newcastle NSW
- Contact:
Re: Coiack failure
Consider the ignition trigger.
http://www.NitroDann.com
speed wrote:If I was to do it again, I wouldn't even consider the supercharger.
-
- Racing Driver
- Posts: 862
- Joined: Sat Jan 01, 2011 2:30 pm
- Vehicle: NA6
- Location: Newcastle
Re: Coiack failure
I had exactly the same symptoms. Rapidly deteriorated (the next run on the track that day it was much worse). I had blown one of my Toyota COP coils. New coil, all fixed.
WP:1.12.492 SMPN:1.16.403 SMPS:1.05.473 SMPGP:1.53.256 SMPB:2.22.181
-
- Speed Racer
- Posts: 3119
- Joined: Tue Mar 11, 2014 8:33 pm
- Vehicle: NA8 - Supercharged
- Location: Brisbane
Re: Coiack failure
bruce wrote:When I had problems with my coiack, my doctor said I should eat more fibre.
Hahahahahha , damn doctors, what would they know.
- bartmanftw
- Fast Driver
- Posts: 451
- Joined: Wed Oct 30, 2013 1:35 pm
- Vehicle: NA6
- Location: Victoria
Re: Coiack failure
As Dann said look at the cam/crank trigger sensors. The tacho is ECU dríven, not coil dríven so if you are getting a misfire and the tacho is dropping out then it is most likely one of your trigger sensors is dropping out.
-
- Driver
- Posts: 97
- Joined: Mon Jan 28, 2013 5:22 pm
- Vehicle: NB8A
- Location: Leopold - 10 minutes out of Geelong VIC
Re: Coiack failure
Thanks for the constructive responses as well as the smart arse ones.
Not a great typist with one finger on an iPad. Sorry guys.
I'll check trigger sensors first before going onto coilpack
Not a great typist with one finger on an iPad. Sorry guys.
I'll check trigger sensors first before going onto coilpack
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 32 guests