Ecliptech shift p2 - install

[The Green Goblin]

Hey fellas,

i recently bought one of these for my NB8B & looking to install shortly.. by install i mean a local shop will do for me. a noob question that i have is, does the gauge hood cover need to come off in order to install the wiring for this device? i have checked the install guide & there are a number of ways to install it, dependent on the car/make, so left me a little confused.

here is the guide im referring to - https://ecliptech.com.au/wp-content/upl ... -Guide.pdf. hoping one who is electronically gifted can enlighten me, as i know sweet jack all about these things.

cheers.

[Magpie]

Have you identified the RPM signal wire? You should be able to do this without pulling the dash out.

https://ecliptech.com.au/wp-content/uploads/2016/12/Shift-P2-Installation-Guide.pdf

[The Green Goblin]

Have you identified the RPM signal wire? You should be able to do this without pulling the dash out.

https://ecliptech.com.au/wp-content/uploads/2016/12/Shift-P2-Installation-Guide.pdf

yep thats the guide (some reason the link in incuded didnt work).

no i haven't located the RPM wire & have no idea where it would be, i would assume behind the gauge instrument cluster? it's not the dash im referring to - but the hood cover, apparently this pulls out quite easily, i just need to know if i do need to take it off/if the RPM signal wire is behind that area.

cheers.

[Magpie]

https://www.flyinmiata.com/support/instructions/misc/shifti.pdf

[The Green Goblin]

https://www.flyinmiata.com/support/instructions/misc/shifti.pdf

thanks mate. i suspected it was behind there.

ta,
jas.