OK, slightly strange issue. Car has been harder to start over the last few months - takes 4-5 seconds of cranking before it will fire. Does this whether its hot or cold. Always starts, just takes a while. If you turn the car off and straight back on, it fires up OK. Leave it sit for a while, takes longer to fire.
However, if I turn the key to "On", wait for 5 seconds, then crank it over, it will start within 1-2 seconds every time.
I've replaced the fuel pump, I thought perhaps it was getting a bit lazy, but that didn't make a difference.
Any suggestions would be appreciated, its more an annoying problem than anything major.
Hard starting NB8B
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
- 1600Dave
- Fast Driver
- Posts: 146
- Joined: Tue May 05, 2015 9:32 am
- Vehicle: NB8B
- Location: Newcastle, NSW
- jordan.k
- Fast Driver
- Posts: 113
- Joined: Mon Oct 17, 2016 2:39 am
- Vehicle: NA6 - Turbo
Re: Hard starting NB8B
If you're saying its fine after you let it prime i'd put my money on the fuel filter being a bit clogged. Probably due for a change anyway.
Have had similar issues on other cars and changing the fuel filter improved starting time noticeably. GL
Have had similar issues on other cars and changing the fuel filter improved starting time noticeably. GL
NA6 Dulux spec
- 1600Dave
- Fast Driver
- Posts: 146
- Joined: Tue May 05, 2015 9:32 am
- Vehicle: NB8B
- Location: Newcastle, NSW
Re: Hard starting NB8B
Ta, I'll grab one and see how it goes.
-
- Speed Racer
- Posts: 11852
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Re: Hard starting NB8B
+1 for fuel filter as first thing to replace.
-
- Driver
- Posts: 90
- Joined: Tue Jun 02, 2015 10:06 pm
- Vehicle: NA8 - Turbo
Re: Hard starting NB8B
jordan.k wrote:If you're saying its fine after you let it prime i'd put my money on the fuel filter being a bit clogged. Probably due for a change anyway.
Have had similar issues on other cars and changing the fuel filter improved starting time noticeably. GL
Spot on!!!!!
- bruce
- Speed Racer
- Posts: 7706
- Joined: Fri Apr 25, 2003 11:00 am
- Vehicle: NA8 - Turbo
- Location: Victoria
- Contact:
Re: Hard starting NB8B
Sounds like a battery too.
This cold weather does mean difficult starting.
This cold weather does mean difficult starting.
- beavis
- Forum sponsor
- Posts: 1405
- Joined: Mon Feb 02, 2009 12:31 pm
- Vehicle: NB8B - Turbo
- Location: Melbourne
Re: Hard starting NB8B
bruce wrote:Sounds like a battery too.
This cold weather does mean difficult starting.
While that is very true, it probably wouldn't explain his symptom of "if I turn the key to "On", wait for 5 seconds, then crank it over, it will start within 1-2 seconds every time."
Turbo NB Build Thread | BeavisMotorsport.com | YouTube.com/bbeavis | Cars: NA6, NA8-VVT, NB-Turbo, ND-2L
-
- Racing Driver
- Posts: 680
- Joined: Mon Nov 25, 2013 7:38 am
- Vehicle: NB8A
- Location: Newcastle
Re: Hard starting NB8B
1600Dave wrote:OK, slightly strange issue. Car has been harder to start over the last few months - takes 4-5 seconds of cranking before it will fire. Does this whether its hot or cold. Always starts, just takes a while. If you turn the car off and straight back on, it fires up OK. Leave it sit for a while, takes longer to fire.
My track NB has been exactly the same for the almost 4 years I've had it. A new fuel filter didn't make any difference. I've tried jumper leads as battery ground & engine ground, but still the same. The strange part is the instant firing on the second start. It performs fine, so I've ignored it.
-
- Speed Racer
- Posts: 11852
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Re: Hard starting NB8B
Yeah, a few forumites have experienced this issue without resolution. Just had a look at Mazda TSBs & found following (Engine hard to start/ excessive cranking time) for NB8A: https://www.miata.net/garage/tsb/sb003_99.html
From memory I think some have also found replacing or checking & cleaning up the Main relay aka EGI relay in the engine bay fuse box has also helped.
From memory I think some have also found replacing or checking & cleaning up the Main relay aka EGI relay in the engine bay fuse box has also helped.
- 1600Dave
- Fast Driver
- Posts: 146
- Joined: Tue May 05, 2015 9:32 am
- Vehicle: NB8B
- Location: Newcastle, NSW
Re: Hard starting NB8B
RS2000 wrote:It performs fine, so I've ignored it.
Likewise. No dramas otherwise, its now becoming my routine to get in the car, turn key to "On", get settled, put seatbelt on, etc, then start it. Starts fine that way, but jump in and try to start it straightaway and it always takes a fair bit of cranking.
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 57 guests