A naïve question
When lifting the NB with a two post hoist do you use the 4 pinch welds. I have searched, lots of info on floor jacks and stands but none on 2 post hoists .
Cheers
Steven
NB 2 post Hoist lifting points HELP
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
wasp47
- Fast Driver
- Posts: 272
- Joined: Tue Jan 03, 2017 2:53 pm
- Vehicle: NB SE
-
NitroDann
- Forum sponsor
- Posts: 10280
- Joined: Thu Nov 05, 2009 12:10 pm
- Vehicle: NA6
- Location: Newcastle NSW
- Contact:
Re: NB 2 post Hoist lifting points HELP
yes
http://www.NitroDann.com
speed wrote:If I was to do it again, I wouldn't even consider the supercharger.
-
Ned Loh
- Fast Driver
- Posts: 166
- Joined: Mon May 26, 2014 12:46 pm
- Vehicle: Non MX-5
Re: NB 2 post Hoist lifting points HELP
Yes. I like to put a small block of wood under so as not to bend the sill. You may find that the car sit on the arm, not the pad. If your hoist arms are fairly short pad might work.
I can take a picture for you if you like but won't be in the short term (no Mx5 on hoist in short term!)
I can take a picture for you if you like but won't be in the short term (no Mx5 on hoist in short term!)
-
hks_kansei
- Speed Racer
- Posts: 6154
- Joined: Tue Feb 03, 2009 10:43 am
- Vehicle: NB8A
- Location: Victoria
Re: NB 2 post Hoist lifting points HELP
They'll be fine on the pinch welds.
The pads are a lot wider than floor Jack pads, and are normally a flat rubberised surface, so the load is spread out and normally won't bend or dent the pinch weld.
The pads are a lot wider than floor Jack pads, and are normally a flat rubberised surface, so the load is spread out and normally won't bend or dent the pinch weld.
1999 Mazda MX5 - 1989 Honda CT110 (for sale) - 1994 Mazda 626 wagon (GF's)
Who is online
Users browsing this forum: No registered users and 3 guests
