Just opened up a BP motor bought to rebuild. Not sure if the crank appearance is normal - all the counterweights have their outer edges machined, with some 8-10mm dia holes drilled a few mm deep (assume balancing drillings), and a couple of Very small drill marks - 2mm dia, less than 1mm deep. The cyl 1 counterweights have a couple of machined flats with numbers stamped in -2, K, 29.
Does this sound normal ?
Do the cams have any numbers cast or stamped on them normally?
thanks
jp 92 NA6, 96 NA8 with Turbo in a clubbie.
NA8 crank appearance
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
manga_blue
- Forum Guru
- Posts: 4897
- Joined: Mon Apr 24, 2006 7:27 pm
- Vehicle: NA8
- Location: Moruya, NSW
-
jp928
- Driver
- Posts: 90
- Joined: Sat Jun 26, 2004 4:48 pm
Re: NA8 crank appearance
Thanks, that looks the same. Excellent!
jp
jp
-
93_Clubman
- Speed Racer
- Posts: 11854
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Re: NA8 crank appearance
jp928 wrote:Do the cams have any numbers cast or stamped on them normally?
From memory '5A' is cast onto them.
-
manga_blue
- Forum Guru
- Posts: 4897
- Joined: Mon Apr 24, 2006 7:27 pm
- Vehicle: NA8
- Location: Moruya, NSW
Re: NA8 crank appearance
Inlet cam on mine has BP and 05 cast on opposite sides of the shaft between 2 and 3. Exhaust has BP and 06.
’95 NA8
-
93_Clubman
- Speed Racer
- Posts: 11854
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 35 guests
