WHINING Walbro High Flow fuel pump

[C-Gazer]

Two years ago I replaced the stock fuel pump with a Walbro High Flow 255 LTS / Hour pump. My NB8B has only done 7000 klm over that time and now once the engine has warmed up the pump produces a loud whine very noticable at idle and low revs. To claify this is not the sound of a normal pump but the sound of a worn motor bearing about to seize. Last night I googled whining Walbro pumps and found pages of complaints and even utube clips of the same whine sound. My plan is to replace the Walbro with a Deatchworks DW200 pump which appears to not have noise problems. Have any other members had similiar whining fuel pumps and are there any other brand pumps I should consider beside Deatschworks?
.

[sailaholic]

walbros are known to be a loud pump with out hearing it it's hard to tell but there's probably nothing wrong with it.


Sent from my iPhone using Tapatalk

[manga_blue]

255lph walbros are known to be a loud pump with out hearing it it's hard to tell but there's probably nothing wrong with it.


Sent from my iPhone using Tapatalk

Fixed.

The 190lph Walbros don't have the same problems, nor are there a whole lot of fakes on the market like there are with the 255s.

[zossy1]

There couldn't be more than a few hundred BP or B6 powered MX5s in the whole world that would need a 255 Walbro (or Deatsch). That is an a$$load of fuel. Almost everyone can get away with a 190. All a 255 will do is overload your FPR and kill it (unless you are running an aftermarket one).

[sailaholic]

Thanks mb. My other experiences was trying to find a walbro for a 600cc bike engine in an open wheel race car as a cheaper alternative to a Bosch Motorsport pump. we didn't care about noise so got recommended the walbro one.

Good to know the 190 is quiet if I ever need one.


Sent from my iPhone using Tapatalk