NB SE - Leaking Water Pump - Help/ideas *video*

prolifik · Postby **prolifik** » Wed Jul 09, 2014 7:59 pm

Hey guys... any ideas where this may be coming from...

Going to have to strip it down... Timing belt was done a week ago.

http://youtu.be/5uALZMuLjak

emily_mx5 · Postby **emily_mx5** » Wed Jul 09, 2014 8:45 pm

just looks like the waterpump outlet gasket hasnt sealed properly. You can unbolt the flange and replace the gasket, make sure to use some hi-temp "gasket goo" to help the seal.

93_Clubman · Postby **93_Clubman** » Thu Jul 10, 2014 11:40 am

prolifik wrote:Timing belt was done a week ago.

Was the water pump also replaced when the timing belt was done?

prolifik · Postby **prolifik** » Thu Jul 10, 2014 10:33 pm

Yea, water pump as well.

I guess ill have to pull everything off again :-(

prolifik · Postby **prolifik** » Sun Jul 13, 2014 12:14 pm

Seems all sorted.... I just put a bunch of gasket goo in between the return pipe where u could see it dropping out from.
Seems to of worked.
But now I get a p0031 cel! Omgggggg
Didn't even touch the 02 sensor..... Is there any checks I can do before replacing?

Thanks for help guys.

93_Clubman · Postby **93_Clubman** » Sun Jul 13, 2014 1:07 pm

O2 sensor can be tested using a multimeter, but don't know what values you should see on the NB SE sensor. Personally I'd reset the ECU by disconnecting the battery & pumping the brake pedal a few times, & see if it replicates the code, as sometimes after doing major maintenance codes can be thrown until things settle.