So my car is super low and the rsr cat back hangs rather low just at the corner of the muffler.
After a few too many scrapes, I've discovered a hole at the base.
It's spluttered some water and carbon when I was doing a check up.
After the water stopped leaking from there, I could feel small bursts of air.
Hence, confirmation that there's a hole where it's been scraping.
Should I be worried about this hole apart from a bit of corrosion?
inb4; raising height tomorrow.
Hole in muffler
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
vincevince
- Driver
- Posts: 50
- Joined: Tue Nov 19, 2013 4:14 am
- Vehicle: NA6
Hole in muffler
You do not have the required permissions to view the files attached to this post.
-
hks_kansei
- Speed Racer
- Posts: 6154
- Joined: Tue Feb 03, 2009 10:43 am
- Vehicle: NB8A
- Location: Victoria
Re: Hole in muffler
get it welded, should be fairly cheap.
1999 Mazda MX5 - 1989 Honda CT110 (for sale) - 1994 Mazda 626 wagon (GF's)
-
Mr Morlock
- Speed Racer
- Posts: 6444
- Joined: Mon Feb 04, 2008 11:40 am
- Vehicle: NB8B
- Location: Melbourne
Re: Hole in muffler
welding is probably not likely to last long but in any event- weld or replace go to an exhaust shop and get your options.
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 96 guests
