Seat mounting

[track_addict]

Hi guys,

I'm after a bit of advice on how to mount my fixed back. Basically I want/need to get lower in the car. I'm tall (6'2") and my head sits quite close to my BD bar so I would like to get my head away from it and further below it as well. My current seat is a Bride Zeta 2 on Bride rails but I would like to change to a seat where the head rest section comes up higher and wont allow my head to roll over the top and smack the roll bar as the Bride does. Whilst I sit lower than stock it just doesn't cut it.

I'm looking for a fixed mount since that seems to be the only way to get low enough and I'm not to keen on making a bracket up. I'm also keen on using the stock mounting points as I don't want to drill holes in the floor pan or remove the stock points. Now, is my only option to make up a mount or are there good mounts available. I have seen the PCI mounts but are they the "best" in terms of sitting low? What are my options?

Thanks guys,

Ash.

[sailaholic]

Garage star also make one for stock floor mounts. Can't comment on how good it is though.

Sent from my GT-I9100 using Tapatalk 2

[track_addict]

Yes I have been looking at the GStar rails as well but I'm still a bit up in the air about the whole thing haha.