Stuck speedo...
Moderators: timk, Stu, zombie, Andrew, -alex, miata
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
Stuck speedo...
Was driving the NB for about 3km when I looked the speedo was reading zero kmh. As I pondered this it came free and works again.
I believe it is not cable dríven. The car was not used for 10 days so can this contribute to this by sticking somehow?
I believe it is not cable dríven. The car was not used for 10 days so can this contribute to this by sticking somehow?
Silver Nomad
2002 NB8C
2002 NB8C
- KevGoat
- Speed Racer
- Posts: 3940
- Joined: Sun Jun 17, 2012 8:48 pm
- Vehicle: NB SE
- Location: Down South, Adelaide, SA
Re: Stuck speedo...
My NA sometimes sits for a few weeks and no problems.
Maybe check the connections at gearbox/instrument panel.
I replaced my cable with a new one a short while ago for a possible noise issue - turned out not to be the cable though It was pretty cheap, so it didn't worry me too much and now I know its a new cable in there. Had I used some common sense and noted what route the cable took behind the dash from the firewall to the instrument panel, it would have been an easy 1/2 hour job....took me 2 hours and a damned sore back
Maybe check the connections at gearbox/instrument panel.
I replaced my cable with a new one a short while ago for a possible noise issue - turned out not to be the cable though It was pretty cheap, so it didn't worry me too much and now I know its a new cable in there. Had I used some common sense and noted what route the cable took behind the dash from the firewall to the instrument panel, it would have been an easy 1/2 hour job....took me 2 hours and a damned sore back
- KevGoat
- Speed Racer
- Posts: 3940
- Joined: Sun Jun 17, 2012 8:48 pm
- Vehicle: NB SE
- Location: Down South, Adelaide, SA
Re: Stuck speedo...
BTW ... I believe NB is electric, so no cable .... duh So just check sender unit & wiring for loose connections ...
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
-
- Driver
- Posts: 29
- Joined: Tue Dec 20, 2011 7:00 pm
- Vehicle: NB SE
- Location: Brisbane
Re: Stuck speedo...
It is probably just a bad connection on the back of the cluster, they have 3 ribbon style cables and it should be pretty obvious where the contact patches are that you can clean up.
If you haven't removed the cowl on top of the cluster there is a few threads about it, the clips can be a bit fragile.
If you haven't removed the cowl on top of the cluster there is a few threads about it, the clips can be a bit fragile.
-
- Speed Racer
- Posts: 11854
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Re: Stuck speedo...
KevGoat wrote:...took me 2 hours and a damned sore back
For any under dash work it's well worth removing the seat so you can lay on your back & even put your feet up on the rear shelf.
This seems to happen occasionally on NB8B:
viewtopic.php?f=29&t=42521
viewtopic.php?f=18&t=48128
The car in the second post was flood affected, & it's thought had an ECU problem as a result, as there was a bunch of things that went wrong with it & eventually forced the owner to off load the car.
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
Re: Stuck speedo...
thanks,,,,I've emailed honki3rider mentioned above with a similar problem and I'll try jiggling the wire harness behind the dash..
Silver Nomad
2002 NB8C
2002 NB8C
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
Re: Stuck speedo...
Just for the record - many owners in the States have reported this problem too(see Miata.net on how to fix it) http://forum.miata.net/vb/showthread.ph ... ost6211281
Briefly - the sender is screwed into the side of the gearbox. The two wires to the speedo join the sender ,soldered on and
filled with goop. Through heat and vibration the poor solder job comes adrift , and loses constant contact.The fix involves re-soldering and replacing goop. The pics make it look do-able.....
Briefly - the sender is screwed into the side of the gearbox. The two wires to the speedo join the sender ,soldered on and
filled with goop. Through heat and vibration the poor solder job comes adrift , and loses constant contact.The fix involves re-soldering and replacing goop. The pics make it look do-able.....
Silver Nomad
2002 NB8C
2002 NB8C
-
- Speed Racer
- Posts: 6444
- Joined: Mon Feb 04, 2008 11:40 am
- Vehicle: NB8B
- Location: Melbourne
Re: Stuck speedo...
Goop- is that an engineering term like "thingy".
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
- zero00
- Speed Racer
- Posts: 3248
- Joined: Mon Apr 12, 2010 6:54 pm
- Vehicle: NB8A
- Location: Sunshine Coast Queensland
Re: Stuck speedo...
Mr Morlock wrote:Goop- is that an engineering term like "thingy".
'GOOP' = 'geez, old owner problem' [relates to previous owner not current]
Roger D-SUNSHINE COAST
2000 NB8A-LP 69.1248|QR Clubman 71.9235|QR Sprint 68.1412
1989 NA6 B-SPEC #77|Toyota GTS86 MT
2000 NB8A-LP 69.1248|QR Clubman 71.9235|QR Sprint 68.1412
1989 NA6 B-SPEC #77|Toyota GTS86 MT
-
- Speed Racer
- Posts: 6444
- Joined: Mon Feb 04, 2008 11:40 am
- Vehicle: NB8B
- Location: Melbourne
Re: Stuck speedo...
I like that - the acronym for Goop- it will get recycled
- taminga16
- Speed Racer
- Posts: 3617
- Joined: Thu Aug 06, 2009 12:22 am
- Vehicle: NC
- Location: Central Victoria
Re: Stuck speedo...
Hey Silvia,
What news on the fix and be aware that not all Goop's are cable and non-ferrous metal friendly!
Greg.
What news on the fix and be aware that not all Goop's are cable and non-ferrous metal friendly!
Greg.
When you turn your car on, does it return the favour?
-
- Racing Driver
- Posts: 677
- Joined: Thu Nov 17, 2011 1:42 pm
- Vehicle: NB8B
- Location: Moffat Beach QLD.
Re: Stuck speedo...
The job's on hold as the speedo has decided to function normally again....possibly cooler weather or I dunno what
But I feel confident to go for it should the problem recur.
Good point about the Goop.......I'll check with Jaycar and see what they say....
But I feel confident to go for it should the problem recur.
Good point about the Goop.......I'll check with Jaycar and see what they say....
Silver Nomad
2002 NB8C
2002 NB8C
- zero00
- Speed Racer
- Posts: 3248
- Joined: Mon Apr 12, 2010 6:54 pm
- Vehicle: NB8A
- Location: Sunshine Coast Queensland
Re: Stuck speedo...
Mr Morlock wrote:I like that - the acronym for Goop- it will get recycled
Thanks MM!! Just sitting here thinking now I have to clean the rubber off my NB after Lakeside yesterday! Not as bad as the 86 guy who's white rocket copped rubber 'splats' all over the front
SPLAT: 'Special Protection Lacking At Track'
Roger D-SUNSHINE COAST
2000 NB8A-LP 69.1248|QR Clubman 71.9235|QR Sprint 68.1412
1989 NA6 B-SPEC #77|Toyota GTS86 MT
2000 NB8A-LP 69.1248|QR Clubman 71.9235|QR Sprint 68.1412
1989 NA6 B-SPEC #77|Toyota GTS86 MT
Return to “MX5 Audio, Electronics & Lighting”
Who is online
Users browsing this forum: No registered users and 233 guests