NC pulling to side
Moderators: timk, Stu, zombie, Andrew, -alex, miata
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
NC pulling to side
Ive been noticing a strange problem the last few days.
When I'm crusing down the motorway, then put my foot on the throttle the car seems to want to steer to the right.
It only happens when the car is under power. There are no strange noises or anything happening out of the ordinary.
I had a wheels alignment a few months ago on the club day.
Any ideas? I'm going to have a look under the car today sometime
When I'm crusing down the motorway, then put my foot on the throttle the car seems to want to steer to the right.
It only happens when the car is under power. There are no strange noises or anything happening out of the ordinary.
I had a wheels alignment a few months ago on the club day.
Any ideas? I'm going to have a look under the car today sometime
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
-
- Speed Racer
- Posts: 3722
- Joined: Sun Jan 18, 2009 10:16 pm
- Vehicle: Non MX-5
- Location: Glasshouse Mountains, QLD
Re: NC pulling to side
check the tyre pressure on the left side front. if that is correct, then start looking at every bolt and bushe under the car.
- JBT
- Speed Racer
- Posts: 7946
- Joined: Tue Jun 03, 2003 11:00 am
- Vehicle: NC
- Location: Brisbane
Re: NC pulling to side
I'd suspect rear suspension. The settings could be wrong (you should have noticed it after the alignment though) or something like a lower control arm or link has become loose causing variable toe or thrust angle.
-
- Speed Racer
- Posts: 2499
- Joined: Thu Jan 13, 2011 12:46 pm
- Vehicle: NB8A
Re: NC pulling to side
Unsure if same issue, but recently my front sway bar moved across, causing the car to pull left..
-
- Fast Driver
- Posts: 293
- Joined: Thu May 12, 2011 1:30 pm
- Vehicle: NC
- Location: NSW sydney
Re: NC pulling to side
Regie, it's the turbo kicking in ;)
-
- Forum Guru
- Posts: 4897
- Joined: Mon Apr 24, 2006 7:27 pm
- Vehicle: NA8
- Location: Moruya, NSW
Re: NC pulling to side
Check under the front wheel arch for a wombat, kangaroo or pedestrian.
’95 NA8
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
Re: NC pulling to side
All fixed. Was a flat right rear tyre....a tad hard to diagnose after 2 14hr nightshirts....I was a bit of a zombie when I posted the original thread
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
-
- Speed Racer
- Posts: 3722
- Joined: Sun Jan 18, 2009 10:16 pm
- Vehicle: Non MX-5
- Location: Glasshouse Mountains, QLD
Re: NC pulling to side
Good to hear it's all fixed. Those nightshirts totally stuff me also. I was close with the flat tyre, just got the wrong opposite corner. Now the question is, why was it so flat to cause issues?Regie wrote:All fixed. Was a flat right rear tyre....a tad hard to diagnose after 2 14hr nightshirts....I was a bit of a zombie when I posted the original thread
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
Re: NC pulling to side
project.r.racing wrote:Good to hear it's all fixed. Those nightshirts totally stuff me also. I was close with the flat tyre, just got the wrong opposite corner. Now the question is, why was it so flat to cause issues?Regie wrote:All fixed. Was a flat right rear tyre....a tad hard to diagnose after 2 14hr nightshirts....I was a bit of a zombie when I posted the original thread
Had a nail in it, slow leak I assume...when I saw it this morning it had 6psi in it....I'm ather lucky I didn't damage the rim down the motorway heading home from work this morning.
Got it plugged, all good now. I was thinking diff bushes, broken ppf... $20 fix and it's as good as new
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
-
- Speed Racer
- Posts: 2499
- Joined: Thu Jan 13, 2011 12:46 pm
- Vehicle: NB8A
Re: NC pulling to side
all good now. I was thinking diff bushes, broken ppf... $20 fix and it's as good as new
Cheering, we need a catch up early July?
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
Re: NC pulling to side
Hjt wrote:all good now. I was thinking diff bushes, broken ppf... $20 fix and it's as good as new
Cheering, we need a catch up early July?
Yes! When's the July club track day? Keen as mustard to get out there
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
- JBT
- Speed Racer
- Posts: 7946
- Joined: Tue Jun 03, 2003 11:00 am
- Vehicle: NC
- Location: Brisbane
Re: NC pulling to side
Regie wrote:Got it plugged, all good now. I was thinking diff bushes, broken ppf... $20 fix and it's as good as new
Good result. It would have been causing similar issues to rear suspension problems - luckily it was the cheapest thing on the rear suspension.
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
Re: NC pulling to side
JBT wrote:Regie wrote:Got it plugged, all good now. I was thinking diff bushes, broken ppf... $20 fix and it's as good as new
Good result. It would have been causing similar issues to rear suspension problems - luckily it was the cheapest thing on the rear suspension.
I reckon, I didn't want to delay my 4.1 install and flash tune
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
- Guran
- Speed Racer
- Posts: 3754
- Joined: Sun Feb 15, 2009 6:42 pm
- Vehicle: ND - 1.5
- Location: Albion Park NSW
- Contact:
Re: NC pulling to side
29 July. You WILL be there right? No teasing now.
Standard 2006 NC - YouTube
WP 1:11.89 | SMP-S 1:05.90 GP 1:54.93 N 1:18.09 L 2:22.49 | PW 1:02.52
PI 2:00.55 | W-S 1:12.44 W-L 1:43.36 | SR 1:33.25
WP 1:11.89 | SMP-S 1:05.90 GP 1:54.93 N 1:18.09 L 2:22.49 | PW 1:02.52
PI 2:00.55 | W-S 1:12.44 W-L 1:43.36 | SR 1:33.25
- Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
Re: NC pulling to side
Guran wrote:29 July. You WILL be there right? No teasing now.
Thanks Bryan, I'll be there!
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
Return to “MX5 Wheels, Suspension, Brakes & Tyres”
Who is online
Users browsing this forum: Google [Bot] and 156 guests