Adding a variable TPS to an NA6
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
AmmoJammo
- Driver
- Posts: 54
- Joined: Sat May 05, 2012 8:23 pm
Re: Adding a variable TPS to an NA6
Whats the difference with bore size?
-
NitroDann
- Forum sponsor
- Posts: 10280
- Joined: Thu Nov 05, 2009 12:10 pm
- Vehicle: NA6
- Location: Newcastle NSW
- Contact:
Re: Adding a variable TPS to an NA6
Well.. And this is just from memory, the laser throttle body has a 5mm smaller throttle plate/bore, and a differently shaped throttle shaft.
Dann
Dann
http://www.NitroDann.com
speed wrote:If I was to do it again, I wouldn't even consider the supercharger.
-
AmmoJammo
- Driver
- Posts: 54
- Joined: Sat May 05, 2012 8:23 pm
Re: Adding a variable TPS to an NA6
VL TPS doesn't fit the Familia B6t throttle body properly, as the shaft is too long.
I might get a VL throttle body, apparently the stock TB is 50mm, while the VL is 55mm, and should bolt straight on.
I might get a VL throttle body, apparently the stock TB is 50mm, while the VL is 55mm, and should bolt straight on.
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 28 guests
