i removed this sensor and can't figure out how to re-install it. this is on an nb8a.
i know that there is a small metal clip which holds the wiring of the sensor out of the way of the harmonic balancer. i wasn't paying enough attention when i removed it and just can't get it right.
could somebody please post a close up picture of the crank position sensor fitted to the block?
thank you!
how to replace crank position sensor? picture please!
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
dude04
- Driver
- Posts: 60
- Joined: Sat Mar 31, 2007 11:21 am
- Vehicle: NC
- Location: sydney
-
dude04
- Driver
- Posts: 60
- Joined: Sat Mar 31, 2007 11:21 am
- Vehicle: NC
- Location: sydney
-
Regie
- Speed Racer
- Posts: 4259
- Joined: Thu May 15, 2008 3:02 pm
- Vehicle: NC - V8
- Location: Sydney
how to replace crank position sensor? picture please!
sweet thanks for the link. i took mine off today for the timing belt change..
it shall be going back on tomorrow
it shall be going back on tomorrow
MY07 NC, Mazdaspeed Body, Ohlins, Full GWR Exhaust, 17x9 RPF1's, 4.1FGR and lots lots more
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 21 guests
