Some custom Daniel Deckers sump baffling

little decks · Postby **little decks** » Sun Mar 28, 2010 11:13 pm

check out this pretty impressive fabrication work dad just did for a customers (John Metham) 1.8 race engine.

he has done a couple of these and i thought this time id take some photos and put them on here.

the main purpose is to prevent oil surge in the engine, which will happen when you start getting your lateral forces up around corners and braking, its a good idea to protect your 200 rear wheel HP naturally aspirated piece of kit from doing bearings etc.

Dweezle · Postby **Dweezle** » Mon Mar 29, 2010 2:05 pm

Very nice..
How much $$$ are we talking for something as neat as this??

Sent from my iPhone using Tapatalk

Hammer · Postby **Hammer** » Mon Mar 29, 2010 2:22 pm

Does he do heatshield fabrication around the turbo/manifold for the SP?

little decks · Postby **little decks** » Mon Mar 29, 2010 5:09 pm

hi guys.

if you supply just the sump already removed from the engine it will be around the $500 mark

and yes he can pretty much any fabrication work, has a mig and a tig welder that can do aluminium, if you have seen photos of sledgehammers car on the forum, all the fabrication work on that was done by dad.