Machining a new perch into my yellow konis

[jamespbeasley]

Hey
Can anyone reccommend somewhere in Sydney (ideally north shore) where I can get this done on my NB8A? I have King Springs and yellow (single perch... obviously) Konis. The backs are a good height, but the fronts sit REALLY low for some unknown reason, so need to raise them about 20mm.
Any suggestions would be greatly appreciated!
James

[Juffa]

Hey
Can anyone reccommend somewhere in Sydney (ideally north shore) where I can get this done on my NB8A? I have King Springs and yellow (single perch... obviously) Konis. The backs are a good height, but the fronts sit REALLY low for some unknown reason, so need to raise them about 20mm.
Any suggestions would be greatly appreciated!
James

Can't help with with an answer....but rather a question.... Are you sure the right springs are the right end of the car....the rear springs are much shorter than the front....you (or the installer) wouldn't be the first to put them in wrong end of the car.

J