POWER-ANTENNA FOR N/A

Audio, Electronics and Lighting questions and answers

Moderators: timk, Stu, -alex, miata, zombie, Andrew

User avatar
Stu
Racing Driver
Posts: 909
Joined: Sun Jan 08, 2006 9:38 pm
Vehicle: NB8B
Location: Melbourne
Contact:

POWER-ANTENNA FOR N/A

Postby Stu » Sat May 30, 2009 11:33 am

Calling MeanMX, your favourite topic is on the forum :mrgreen:

User avatar
JBT
Speed Racer
Posts: 7946
Joined: Tue Jun 03, 2003 11:00 am
Vehicle: NC
Location: Brisbane

POWER-ANTENNA FOR N/A

Postby JBT » Sat May 30, 2009 5:04 pm

I think about the only type that will fit is the Mazda one.
Image

User avatar
Benny
Speed Racer
Posts: 2607
Joined: Wed Apr 23, 2003 11:00 am
Vehicle: NB SP
Location: Gorgeous Sydney
Contact:

POWER-ANTENNA FOR N/A

Postby Benny » Thu Jun 04, 2009 5:37 pm

Save yourself the hassle and just put a rubber duck antenna on it.
That way, you won't have to worry about a relay either.
Image
ALWAYS RUNNING, SP with Bilstein Coil Overs and Doof Doof sound. Member of the Fat Bastards Racing Team

User avatar
PhilM
Fast Driver
Posts: 295
Joined: Fri Jul 27, 2007 9:55 pm
Vehicle: NA6
Location: Lake Macquarie

POWER-ANTENNA FOR N/A

Postby PhilM » Tue Aug 04, 2009 10:29 pm

Did you have any luck getting an ant?
I need one as well - I cant leave the ant up as I pull over a cover.
Phil
Rosso Corsa Red NA V Special

RG.net
Racing Driver
Posts: 1692
Joined: Thu Apr 06, 2006 7:48 pm
Vehicle: NA6
Location: Sydney
Contact:

POWER-ANTENNA FOR N/A

Postby RG.net » Tue Aug 04, 2009 11:51 pm

i have my power antenna for sale.

viewtopic.php?f=44&t=37729

pretty sure it will work with the NA's, i'm sure someone can confirm here.
http://Run-It-Hard.com - We're here to have fun!

User avatar
PhilM
Fast Driver
Posts: 295
Joined: Fri Jul 27, 2007 9:55 pm
Vehicle: NA6
Location: Lake Macquarie

POWER-ANTENNA FOR N/A

Postby PhilM » Wed Aug 05, 2009 8:58 am

Thanks for the reply mxhevn -
The NA has a short distance from the guard to the wheel arch. So if yours is about 250mm or less from the part that goes under the mud guard to the lowest point (water drain exit to the pipe).
I will also need the male plug if you have it -as mine just has + & - wires with round wire connectors - but I can solder them to the correct plug.
If thats OK we will have a sale
Phil
Rosso Corsa Red NA V Special

RG.net
Racing Driver
Posts: 1692
Joined: Thu Apr 06, 2006 7:48 pm
Vehicle: NA6
Location: Sydney
Contact:

POWER-ANTENNA FOR N/A

Postby RG.net » Wed Aug 05, 2009 12:29 pm

PhilM wrote:Thanks for the reply mxhevn -
The NA has a short distance from the guard to the wheel arch. So if yours is about 250mm or less from the part that goes under the mud guard to the lowest point (water drain exit to the pipe).
I will also need the male plug if you have it -as mine just has + & - wires with round wire connectors - but I can solder them to the correct plug.
If thats OK we will have a sale
Phil


this is the factory NB antenna, i'm sure its a similar length to the NA antenna, as they are located in the same position, but on opposite sides.
http://Run-It-Hard.com - We're here to have fun!

User avatar
Locutus
Racing Driver
Posts: 879
Joined: Thu Jul 26, 2007 7:39 pm
Vehicle: NB SP
Location: Sydney
Contact:

POWER-ANTENNA FOR N/A

Postby Locutus » Thu Aug 06, 2009 1:22 am

pretty sure NB isn't direct fit because the shape of the rear quarter panels and positioning of antennas are different. NAs have the antenna mounted on a flatter surface.

User avatar
PhilM
Fast Driver
Posts: 295
Joined: Fri Jul 27, 2007 9:55 pm
Vehicle: NA6
Location: Lake Macquarie

POWER-ANTENNA FOR N/A

Postby PhilM » Fri Aug 07, 2009 9:45 am

Thanks Locutus -your right
I checked out a neighbours NB yesterday - I did not pull his internal boot liner to check the length. I think I can cut the wedge shaped rubber grommet at a lower angle to suit the NA.
I have a manual retractable aerial on now that is short enough but it is is not sealed - designed to go in a mudguard that is drained to the outside- in theNA it drains in the boot when it rains.
I'll buy MXHEVN s - If its too long I'll resell it back to a NB.
Phil
Rosso Corsa Red NA V Special

User avatar
PhilM
Fast Driver
Posts: 295
Joined: Fri Jul 27, 2007 9:55 pm
Vehicle: NA6
Location: Lake Macquarie

POWER-ANTENNA FOR N/A

Postby PhilM » Mon Aug 17, 2009 8:39 pm

Well I bought MXHEVNs electric NB - but unfortunately its about 60mm too long for the NA . so its on the market again - same price -$100.00
So pm me if you need an NB elect arial.
Rosso Corsa Red NA V Special

User avatar
corners
Racing Driver
Posts: 1127
Joined: Mon Aug 20, 2007 1:33 pm
Vehicle: ND - Supercharged
Location: Brisbane, QLD

POWER-ANTENNA FOR N/A

Postby corners » Tue Aug 18, 2009 3:10 pm

Where is the best place to get a rubber antenna from?
Steampunk wrote: Oh you've got Ohlins? You must like drugs too!!!

User avatar
bruce
Speed Racer
Posts: 7782
Joined: Fri Apr 25, 2003 11:00 am
Vehicle: NA8 - Turbo
Location: Victoria
Contact:

POWER-ANTENNA FOR N/A

Postby bruce » Tue Aug 18, 2009 4:12 pm

Any rubber antenna is suitable, but you will need an adaptor as the threads are a different diameter. I bought mine for a store many moons ago.
Regards car covers, just cut a slit into it for the rubber antenna.


Return to “MX5 Audio, Electronics & Lighting”

Who is online

Users browsing this forum: No registered users and 2 guests