Annoying squeaking sound
Moderators: timk, Stu, zombie, Andrew, -alex, miata
- sliq
- Speed Racer
- Posts: 3414
- Joined: Sat Jan 13, 2007 12:33 am
- Vehicle: ND - 2 GT
- Location: Sydney
- Contact:
Annoying squeaking sound
Hey Guys,
My car has this very annoying squeaking sound whenever i'm on bumpy road, or pretty much anything that makes my car vibrate. It sounds like there are mice in my car.. Squeak Squeak!
It first started coincidentally when i removed my centre console.. I removed the console again this morning and tightened up all the bolts.. Still same squeaky sound whenver I go over bumpy road or speed bumps..
Any clues? I've tried reading up on miata.net but no help there..
TIA.
My car has this very annoying squeaking sound whenever i'm on bumpy road, or pretty much anything that makes my car vibrate. It sounds like there are mice in my car.. Squeak Squeak!
It first started coincidentally when i removed my centre console.. I removed the console again this morning and tightened up all the bolts.. Still same squeaky sound whenver I go over bumpy road or speed bumps..
Any clues? I've tried reading up on miata.net but no help there..
TIA.
i can't brain today.. i have the dumb..
- redwards
- Fast Driver
- Posts: 244
- Joined: Sat Feb 02, 2008 8:43 pm
- Location: Melbourne, Victoria
- sliq
- Speed Racer
- Posts: 3414
- Joined: Sat Jan 13, 2007 12:33 am
- Vehicle: ND - 2 GT
- Location: Sydney
- Contact:
Re:
JBT wrote:If you think it has something to do with the console, take it out and test drive.
I had a squeek in my NA - it was actually the rubber stoppers for the boot lid. A very thin smear of Armorall fixed it.
yup, i removed the centre console and took it for a drive around the block, still squeaky squeak.
i can't brain today.. i have the dumb..
- Gazbo
- Fast Driver
- Posts: 244
- Joined: Fri Jul 14, 2006 8:16 pm
- Vehicle: ND - 2 GT
- Location: Sydney-ish
I found that my radio was rubbing against the inside of the console, a bit of foam tap fixed that.
Then the metal clips that the radio screws into started rattling, more foam tape...
The bonnet tends to squeak on the catch and rubber stoppers. Lubricate the catch and put felt pads on the rubber stops.
I also found the door trims (cards) would squeak against the door. I padded this with yet more foam tape.
A dull plasticy rattle turned out to be sides of the dash vibrating. I'm referring to the part that is covered by the doors when closed. This was solved by stuffing the cavity between the metal dash ends and the plastic ends with blocks of soft foam. This stops the plastic resonating, hence no more rattle.
Also try securing any loose cable looms behind the dash with cable ties.
Could I recommend you buy a roll of foam tape?
I still have a metallic buzz coming from the centre console which occurs around 3000-3500 rpm. Very annoying, and I just can't trace it. I'm sure it's NOT heat shields rattling.
Then the metal clips that the radio screws into started rattling, more foam tape...
The bonnet tends to squeak on the catch and rubber stoppers. Lubricate the catch and put felt pads on the rubber stops.
I also found the door trims (cards) would squeak against the door. I padded this with yet more foam tape.
A dull plasticy rattle turned out to be sides of the dash vibrating. I'm referring to the part that is covered by the doors when closed. This was solved by stuffing the cavity between the metal dash ends and the plastic ends with blocks of soft foam. This stops the plastic resonating, hence no more rattle.
Also try securing any loose cable looms behind the dash with cable ties.
Could I recommend you buy a roll of foam tape?
I still have a metallic buzz coming from the centre console which occurs around 3000-3500 rpm. Very annoying, and I just can't trace it. I'm sure it's NOT heat shields rattling.
Daily: 2006 "C" Mazda3 SP23
Fun: 1993 NA6
Fun: 1993 NA6
- Garry
- Speed Racer
- Posts: 3481
- Joined: Sun Apr 27, 2003 11:00 am
- Vehicle: NB SP
- Location: God's Country
- Contact:
Try moving the bottom of the dash down near where the console attaches. If you hear the squeak it could be the screw near the back of the centre pocket in the console just in front of the heater box that holds the dash to the transmission tunnel. You'll need to climb in behind the dash to tighten it up with a stumpy phillips head screw driver. While your under there you can tighten up all the other screws that hold the plastic dash to the metal frame, they will probably be loose too.
Shiney black one with added red bits. Member of the fart club. Now with extra doof and Sunlong. - deceased and gone to heaven
- chrislevingston
- Fast Driver
- Posts: 171
- Joined: Sat May 03, 2003 11:00 am
- Vehicle: ND - 2 GT
- Location: Adelaide
- Contact:
- chrislevingston
- Fast Driver
- Posts: 171
- Joined: Sat May 03, 2003 11:00 am
- Vehicle: ND - 2 GT
- Location: Adelaide
- Contact:
- Patty
- Driver
- Posts: 92
- Joined: Sat Sep 15, 2007 10:39 am
- Vehicle: NB8A
- Location: Sydney
-
- Racing Driver
- Posts: 1692
- Joined: Thu Apr 06, 2006 7:48 pm
- Vehicle: NA6
- Location: Sydney
- Contact:
i just recently got a squeak too sounds like its from the passenger side near my seat, i shake my seat but it doesnt squeek, i'll find it this weekend with this bad boy http://granitegrok.com/pix/soldier_size_mouse_trap.jpg
http://Run-It-Hard.com - We're here to have fun!
- sliq
- Speed Racer
- Posts: 3414
- Joined: Sat Jan 13, 2007 12:33 am
- Vehicle: ND - 2 GT
- Location: Sydney
- Contact:
Re:
MXHEVN wrote:i just recently got a squeak too sounds like its from the passenger side near my seat, i shake my seat but it doesnt squeek, i'll find it this weekend with this bad boy http://granitegrok.com/pix/soldier_size_mouse_trap.jpg
LOL!! and to think these soldiers were trained to be in danger.. tsk tsk.. hehe
if that yank was smart enough, he'd be pulling the beer from the other side
i can't brain today.. i have the dumb..
Return to “MX5 Body, Paint, Interior & Trim”
Who is online
Users browsing this forum: No registered users and 155 guests