It will make more sense when you do it.
Tightening hardtop at frankenstien bolts
Moderators: timk, Stu, -alex, miata, zombie, Andrew
-
Okibi
- Speed Racer
- Posts: 10906
- Joined: Thu Aug 21, 2003 11:00 am
- Vehicle: NB SE
- Location: Perth, Western Australia
- Contact:
Theres a philips head screw on the metalic bits at the back of your hardtop. Look on the inside edge of both (i think) take that screw out, the top part of the metalic piece will pivot across, then you can adjust the 2 bots that hold the C shaped part that grips the Frankenstein bolts.
It will make more sense when you do it.
It will make more sense when you do it.
If you had access to a car like this, would you take it back right away? Neither would I.
-
Garry
- Speed Racer
- Posts: 3481
- Joined: Sun Apr 27, 2003 11:00 am
- Vehicle: NB SP
- Location: God's Country
- Contact:
There is a plastic coating on the adjusting shims that may have worn through. If it has you can flip the shim over and use the other side. You might also want to check where the soft top latch rests against the stoppers on the hardtop. My car squeaks from there really badly. I use 2 little pieces of cardboard between the latch and the stopper to stop the squeaks.
Shiney black one with added red bits. Member of the fart club. Now with extra doof and Sunlong. - deceased and gone to heaven
Return to “MX5 Body, Paint, Interior & Trim”
Who is online
Users browsing this forum: No registered users and 5 guests
