Air Vents

Body, Paint, Interior and Trim questions and answers

Moderators: timk, Stu, zombie, Andrew, -alex, miata

Rooster
Driver
Posts: 32
Joined: Sat Apr 14, 2007 4:19 pm
Vehicle: ND - 2 GT
Location: Mid north coast

Air Vents

Postby Rooster » Fri Aug 17, 2007 5:56 pm

Hi Fellers,
The air vents on the dash of my 2002 MX5 slowly vibrate down after a few k's any simple remedy other than jamming something into them? :?

The Rooster

User avatar
Ajay
Racing Driver
Posts: 901
Joined: Mon Dec 11, 2006 6:07 pm
Vehicle: NA6
Location: Western Sydney, NSW
Contact:

Postby Ajay » Fri Aug 17, 2007 6:01 pm

i believe they have a piece of foam at the base (that keep them firmly in place) this wears away after time.. maybe pop the air vent out and take it apart and have a geez :D
Image

User avatar
Uncle Arthur
Dodgy Award Benefactor
Posts: 1802
Joined: Wed Apr 23, 2003 11:00 am
Vehicle: ND - 2 GT
Location: Doesn't matter where I'm from-it's that your daughter is with me that's the biggest concern :D
Contact:

Postby Uncle Arthur » Fri Aug 17, 2007 6:01 pm

Pull them apart and replace the little felt pads that stop them from drooping.......

It's an easy job even for the tech challenged.....
Founder of the QLD Chapter of the Honourable Brothers of Dodgy.

Benefactor of the Perpetual Dodgy award - Inaugural year 2007.

User avatar
Ajay
Racing Driver
Posts: 901
Joined: Mon Dec 11, 2006 6:07 pm
Vehicle: NA6
Location: Western Sydney, NSW
Contact:

Postby Ajay » Fri Aug 17, 2007 6:18 pm

thats what i mean FELT not foam.. thanks UA
Image

Rooster
Driver
Posts: 32
Joined: Sat Apr 14, 2007 4:19 pm
Vehicle: ND - 2 GT
Location: Mid north coast

Air Vents

Postby Rooster » Fri Aug 17, 2007 8:53 pm

Thanks fellers
I knew I would get good advice, I will check tomorrow and see if I can remove them without too much agro. :oops:

User avatar
Captain Spank
Fast Driver
Posts: 105
Joined: Tue Jan 23, 2007 12:22 pm
Vehicle: NA6
Location: Victoria

Postby Captain Spank » Fri Aug 17, 2007 9:30 pm

Best way to pop them out is with something like packing tape (you know the blue plastic strip stuff you find large around cardboard boxes that you need a knife to cut off). Thread that through and loop it back and then give it a 'solid' direct pull...may help to put knees or feet on dash in some cases.

Don't use wire as it's too thin and will dint & bend the back part of the vent balls plastic.

Just a tip I learn't through trial and error. :D

Pretty easy job though, have fun.

CS

User avatar
jules
Guitar Hero
Posts: 3562
Joined: Thu Apr 24, 2003 11:00 am
Vehicle: NA6
Location: Sydney, previously HQ - GC Dodgy Inc.
Contact:

Postby jules » Fri Aug 17, 2007 9:35 pm

Sometimes you can get away with just pushing them in a bit. It holds them a bit tighter.

Jules
Founder of the Gold Coast Chapter of the Honourable Brothers of Dodgy.
Image

User avatar
Alex
Racing Driver
Posts: 1654
Joined: Thu Jan 04, 2007 6:54 am
Vehicle: NB8A
Location: Sydney

Postby Alex » Sat Aug 18, 2007 1:18 am

I'm amazed that i haven't had this problem, if anything mine are too hard to move, expecially the centre ones :?
Image
Red NB8A - BD rollbar - Hardtop

RG.net
Racing Driver
Posts: 1692
Joined: Thu Apr 06, 2006 7:48 pm
Vehicle: NA6
Location: Sydney
Contact:

Postby RG.net » Sun Aug 19, 2007 11:15 pm

mine sag like to tomorrow!

i push mine in but 2 mins later they droop again, where do you get this \"felt\" from? mazda i presume :roll:
http://Run-It-Hard.com - We're here to have fun!

User avatar
Bevan
Speed Racer
Posts: 2599
Joined: Tue Nov 16, 2004 8:18 pm
Vehicle: ND - 2 GT
Location: N-West Sydney

Re:

Postby Bevan » Sun Aug 19, 2007 11:28 pm

Crocaine wrote:mine sag like to tomorrow!

i push mine in but 2 mins later they droop again, where do you get this "felt" from? mazda i presume :roll:
Try Lincraft or Spotlight... :P Just ask for some sticky felt. 8)

User avatar
ampz
Racing Driver
Posts: 814
Joined: Fri Sep 23, 2005 9:56 pm
Vehicle: NA6 - Turbo
Location: siiiidaneeey
Contact:

Re:

Postby ampz » Mon Aug 20, 2007 7:54 am

Bevan wrote:Try Lincraft or Spotlight... :P Just ask for some sticky fur. 8)


:shock:

Chew Bakka Outfit? :P

(hides) :lol:
Huh?

User avatar
Garry
Speed Racer
Posts: 3481
Joined: Sun Apr 27, 2003 11:00 am
Vehicle: NB SP
Location: God's Country
Contact:

Postby Garry » Mon Aug 20, 2007 10:32 am

Bunnings sell it too.
Shiney black one with added red bits. Member of the fart club. Now with extra doof and Sunlong. - deceased and gone to heaven


Return to “MX5 Body, Paint, Interior & Trim”

Who is online

Users browsing this forum: No registered users and 165 guests