Looking for a good wheel repairer in the sydney area. Have some wheels with major gutter rash that I would like fixed up.
Anybody know of one? I heard there is a good one in Seven Hills but am yet to find out the name of the business or where it is.
Wheel repairer in Sydney. Help?
Moderators: timk, Stu, zombie, Andrew, -alex, miata
- JSE
- Racing Driver
- Posts: 643
- Joined: Mon Jan 02, 2006 10:38 am
- Vehicle: ND - 2 GT
- Location: sydney
-
- godfather of saké
- Posts: 1457
- Joined: Wed Apr 23, 2003 11:00 am
- Vehicle: ND - 2 GT
- Location: Sydney Australia
- Contact:
I've just dealt with a place called Wheel Repair Centre in Thornleigh. 9980 1125. Very good to deal with.
Japanese Nostalgic Car Magazine - Dedicated to classic japanese cars
- bigdog
- King of the kennel
- Posts: 2233
- Joined: Wed May 25, 2005 3:07 pm
- Vehicle: NB SP
- Location: Blue Mountains
- Contact:
- Fuzzlet
- Racing Driver
- Posts: 1077
- Joined: Sat Feb 25, 2006 6:35 pm
- Vehicle: ND - 2 GT
- Location: Berowra
- Contact:
Re:
Babalouie wrote:I've just dealt with a place called Wheel Repair Centre in Thornleigh. 9980 1125. Very good to deal with.
I bit of a thread mine here, but I've just dropped 2 wheels off to these guys for repair:
1 nasty pothole in arcadia long enough to swallow the rim, caused this x2. It was a bad enough hit, that I lost the air out of both left tyres, and the rims have been buckled and knocked out of alignment...ie when they spun them up to check out the damage, they dont spin properly....gonna cost the better part of $200 per rim, plus a new tyre for the front...it had a chunk taken out of it....thank god I wasnt in the MX5 though....I would of destroyed my front suspension
Current: Red 04 SE (Slightly modified) - 133rwkw@7psi - Winner of the Mania Dyno Day 2008
Previous: Titanium 04 SE (Standard)
White 94 NA (Severely Modified) - 180rwkw - Runner up at the Mania Dyno Day 2007
Previous: Titanium 04 SE (Standard)
White 94 NA (Severely Modified) - 180rwkw - Runner up at the Mania Dyno Day 2007
- Garry
- Speed Racer
- Posts: 3481
- Joined: Sun Apr 27, 2003 11:00 am
- Vehicle: NB SP
- Location: God's Country
- Contact:
- Fuzzlet
- Racing Driver
- Posts: 1077
- Joined: Sat Feb 25, 2006 6:35 pm
- Vehicle: ND - 2 GT
- Location: Berowra
- Contact:
Re:
Garry wrote:Can they repair that?! I might get my stock rim repaired. It was no where near as bad as that.
Yes, but its gonna cost about 200 per wheel for repairs...Its still better than the $500ish per wheel for a full replacement....bloody rays forged rims...
Current: Red 04 SE (Slightly modified) - 133rwkw@7psi - Winner of the Mania Dyno Day 2008
Previous: Titanium 04 SE (Standard)
White 94 NA (Severely Modified) - 180rwkw - Runner up at the Mania Dyno Day 2007
Previous: Titanium 04 SE (Standard)
White 94 NA (Severely Modified) - 180rwkw - Runner up at the Mania Dyno Day 2007
- adamjp
- Racing Driver
- Posts: 519
- Joined: Thu Aug 28, 2003 11:00 am
- Vehicle: NA6
- Location: Sthn NSW
- Contact:
Most good wheel repairers can fix a knock like that. The wheel is not round anymore, so it is a 'simple' matter of making it round again.
What most cannot fix is when the wheel is buckled across the rotating axis, ie. one spoke is further in/out than the others, like when you slide sideways into a gutter with the wheel not rotating. Apparently this is an almost unfixable issue.
It is easy enough to spot, place the wheel on something that allows it to spin, and spin it. Look from above so that you are looking down on the area normally covered by the tyre. Any wobble will show up as plain as day.
I found this out the hard way with a set of Enkeis. The stuffed one wobbled so much in one spot it kinda made me motion sick.
What most cannot fix is when the wheel is buckled across the rotating axis, ie. one spoke is further in/out than the others, like when you slide sideways into a gutter with the wheel not rotating. Apparently this is an almost unfixable issue.
It is easy enough to spot, place the wheel on something that allows it to spin, and spin it. Look from above so that you are looking down on the area normally covered by the tyre. Any wobble will show up as plain as day.
I found this out the hard way with a set of Enkeis. The stuffed one wobbled so much in one spot it kinda made me motion sick.
Adam
RX7AFM PortedHead 11.5:1 HKS264Cams&Gears CeramicCoatedExtractors FlowExhaust Strut&BodyBraces Eibachs Konis SparcoRims Striped
RX7AFM PortedHead 11.5:1 HKS264Cams&Gears CeramicCoatedExtractors FlowExhaust Strut&BodyBraces Eibachs Konis SparcoRims Striped
Not in the hills district but worth the drive:
Magman in Punchbowl.
21 Moxon Road Punchbowl (In the side street where Bankstown Subaru is, off Canterbery Road)
T: 02 9709 2686
Greg I think his name is.
Has straightened 2 set of wheels for me in the past. A set of 18\" MOMO's that came up perfect, and recently rolled out 3 buckles & resprayed a set for the 5 for $400. . .perfect.
But be warned. He can talk. . . and talk. . .and talk. . . which is not always a bad thing.
Magman in Punchbowl.
21 Moxon Road Punchbowl (In the side street where Bankstown Subaru is, off Canterbery Road)
T: 02 9709 2686
Greg I think his name is.
Has straightened 2 set of wheels for me in the past. A set of 18\" MOMO's that came up perfect, and recently rolled out 3 buckles & resprayed a set for the 5 for $400. . .perfect.
But be warned. He can talk. . . and talk. . .and talk. . . which is not always a bad thing.
Return to “MX5 Wheels, Suspension, Brakes & Tyres”
Who is online
Users browsing this forum: Bing [Bot], Google [Bot] and 170 guests