Door speakers NA8

Ralphff · Postby **Ralphff** » Thu Jun 01, 2006 6:40 pm

Hello

,
I want to replace the door speakers in my NA8, I've messured them at 6 inchs. This size seems hard to come by. Will a set of 6.5 inch speakers fit in the original cut outs? I don't really want to hack into the doors, I'd like to leave the door trims original. Can anyone recomend a brand of good quaity two way or three way's? Would't mind a set of splits even as log as I don't have to cut into anything.
Any help would be greatfuly recived :mrgreen:

Brad · Postby **Brad** » Thu Jun 01, 2006 7:21 pm

I have JL Audio 6\" splits which fit perfectly. The tweeters are tied to the air vents in the corner of the dash by little zip ties which are under the tweeter and allow it to sit flush.

Most decent 2-ways of this size are 6\". You won't see any real benefit from a 6.5\".

Astroboysoup · Postby **Astroboysoup** » Thu Jun 01, 2006 8:29 pm

spend the extra money and get the splits.

much better quality and better sound. you won't regret it but it does cost a bit more.

I spent $300 on a pair of DLS splits.

http://cgi.ebay.com.au/DLS-Ultimate-UR6 ... dZViewItem

sab · Postby **sab** » Thu Jun 01, 2006 9:40 pm

Has anyone put 8\" speakers in the doors of an NA?

How much modification would be required?

Astroboysoup · Postby **Astroboysoup** » Thu Jun 01, 2006 10:24 pm

possible.. you'll need to dremel a bigger whole in the door frame to mount the speaker.

you'll probally want to make a MDF ring to mount the speaker on to as well.

and i don't know about the mount depth... you might be lucky witha cheaper 8\" speaker but anything with a mig magnet might not fit in the door.

you'll then need to cut in to the door panel to make it all nice.

maybe alot of sound dampening too to keep the door from vibrating like crazy too....

hmmm

i might try it.

kitkat · Postby **kitkat** » Thu Jun 01, 2006 11:29 pm

8\" go in the rear shelf...
ive put 6\" in the rear and it sounds great even with the top down.

here's the write up from miata.net
http://www.miata.net/hakuna/subspeak.html

Ralphff · Postby **Ralphff** » Thu Jun 01, 2006 11:59 pm

6 inch splits seem to be the go, do you need an amp to drive splits or will an aftermarket head be ok? I'd rather not fit a amp :shock:

kitkat · Postby **kitkat** » Fri Jun 02, 2006 12:01 am

no need for an amp, im running four 6\" off our headunit.
ofcourse an amp would be better but its not necessary.

Ralphff · Postby **Ralphff** » Fri Jun 02, 2006 12:07 am

Thanks for the info guys very helpful. :mrgreen:

Brad · Postby **Brad** » Fri Jun 02, 2006 9:14 am

I run mine off the headunit for about a year until I bothered to put a 4x30w amp in and BOY does it make a HUGE difference. The Headunit was by no means underpowered (45x claimed) but in reality this is only around 10w RMS and the dynamic range is much less. If you have an amp or can afford one get it.

JBT · Postby **JBT** » Fri Jun 02, 2006 9:26 am

I put in JL Audio TR600 6\" two ways. I had to drill one or two mounting holes and use those clip on self tapper washer things. They hide under the original door trims and sound great. I can hear the music etc. no problem at 100+km/hr roof down. No amp and a Sony head unit of ?? age.

sabretooth · Postby **sabretooth** » Sun Jun 04, 2006 8:13 pm

The SQ increase I got by changing to an aftermarket headunit (from the standard cassette deck) was noticeable - and then the SQ increase again from going to that to the amp was even more noticeable. My problem at the moment with my Jaycar splits is that I have nowhere to mount the tweeter, and they rattle the crap out of the door trim!