Brisbane - MX5 / Lotus Club Run Mt Tamborine - 19/3/06
Moderators: timk, Andrew, miata, AJ
-
timk
- Racing Driver
- Posts: 1928
- Joined: Fri Dec 31, 2004 3:16 pm
- Vehicle: NC
-
jules
- Guitar Hero
- Posts: 3562
- Joined: Thu Apr 24, 2003 11:00 am
- Vehicle: NA6
- Location: Sydney, previously HQ - GC Dodgy Inc.
- Contact:
-
sabretooth
- Speed Racer
- Posts: 2119
- Joined: Wed Apr 23, 2003 11:00 am
- Vehicle: NA8 - Turbo
Goddamn. Oil, or fuel?
I believe the valve stem seals may be going. Was it after cruising and then getting on the throttle that it happened? Pulling the head to do the valve stem seals would be much easier than worn piston rings!
It is a 16yr old motor, I guess I can forgive it if it's having a couple of hiccups. I guess it just means I'd better hurry up with the rebuild of the original engine block.
I believe the valve stem seals may be going. Was it after cruising and then getting on the throttle that it happened? Pulling the head to do the valve stem seals would be much easier than worn piston rings!
It is a 16yr old motor, I guess I can forgive it if it's having a couple of hiccups. I guess it just means I'd better hurry up with the rebuild of the original engine block.
-
jules
- Guitar Hero
- Posts: 3562
- Joined: Thu Apr 24, 2003 11:00 am
- Vehicle: NA6
- Location: Sydney, previously HQ - GC Dodgy Inc.
- Contact:
I was actually thinking valve stem seals at the time. It was at its worst when coming on the throttle after coasting on a downslope.
Not a fresh oil smell though, more of a smokey, powdery kind of smell. Black smoke as well. It's probably also running rich too I expect?
Jules
Not a fresh oil smell though, more of a smokey, powdery kind of smell. Black smoke as well. It's probably also running rich too I expect?
Jules
Founder of the Gold Coast Chapter of the Honourable Brothers of Dodgy.
Who is online
Users browsing this forum: No registered users and 92 guests
