I have to replace my waterpump so at the same time was thinking of changing cams,I have the standard Na cams on there at the moment,have a set of B6T cams off the Familia and also a set of Maruha cams but for Na applications,have a set of adjustable cam wheels,what would you use?
Also a set of 4.875 crown wheel and pinion,how do you think that would go?
Thanks
Terry
what cams to use?
Moderators: timk, Stu, zombie, The American, Lokiel, -alex, StanTheMan, greenMachine, ManiacLachy, Daffy, Sean
-
spikey
- Fast Driver
- Posts: 453
- Joined: Mon Mar 14, 2005 1:32 pm
- Vehicle: ND - 2 GT
- Location: Perth W.A.
-
Woo
- Fast Driver
- Posts: 359
- Joined: Tue Oct 12, 2004 12:43 am
- Vehicle: 10AE - Turbo
- Location: OES Melbourne
- Contact:
what cams to use?
The cams with the highest lift would be a good place to start. Then put adj. gears on them.
Factory cams dont benefit from gears when FI (NB specific)
Bazz
Factory cams dont benefit from gears when FI (NB specific)
Bazz
Very slightly modified 10AE #2562 ..... one of 149 in Australia 
Race what you brung ..... And hope you brung enough
Race what you brung ..... And hope you brung enough
-
irwin83r
- Racing Driver
- Posts: 1563
- Joined: Wed Feb 25, 2004 8:32 pm
- Vehicle: NB8A
- Location: wollongong
- Contact:
what cams to use?
4.8 end ratio is pretty short.. if you making a turbo motor thats putting out over 150rwkw i dont think you'd need to go that short.. you'd probably make enough torque to stay around 3.9 or 4.1
but i guess it all depends on the type of driving you want to do..
as for cams i hear steer clear of over lap but maintain a higher lift and enlarge the valve sizes as much as possible.
talk to ct he has a bit of knowledge about suitable cams
but i guess it all depends on the type of driving you want to do..
as for cams i hear steer clear of over lap but maintain a higher lift and enlarge the valve sizes as much as possible.
talk to ct he has a bit of knowledge about suitable cams
Return to “MX5 Forced induction (Turbo/Supercharger)”
Who is online
Users browsing this forum: No registered users and 80 guests
