mx5cartalk.com

Hi guys. I've just had the front spoiler and nose repainted and have addes a splitter to protect the fresh paint job. Work was carried out by MX5 Factory. Thanks to Dick and his crew.






And here are a couple of other shots with some extra goodies.




Hope you enjoy!

It looks awesome with it. Just a nice little touch that finishes off the front really well.

Mind giving some details about it?

I agree with Zawrilla, looks really nice. It finishes off the edge of the normal lip and removes the rounded edge from it.

It's a Miata Air Splitter/Protector put out by Track Dog Racing. I purchased it from James at MX5 Centre in Melbourne

i like what i see

Nice.

Any idea what it's made of?

"The Track Dog Racing™ Air Splitter defends your car's end against scraping and cracking. The protective splitter slides over pavement with steep approach angles while your car's flexible urethane bumper or air dam flexes -- without scratching your paint. Made from 3/16" thick, high-impact ABS plastic and built to take a surprising amount of abuse."

http://www.trackdogracing.com/website/air_splitters.htm

looks good

they don't has for garage vary lips, unfortunately

MXHEVN wrote:"The Track Dog Racing™ Air Splitter defends your car's end against scraping and cracking. The protective splitter slides over pavement with steep approach angles while your car's flexible urethane bumper or air dam flexes -- without scratching your paint. Made from 3/16" thick, high-impact ABS plastic and built to take a surprising amount of abuse."

http://www.trackdogracing.com/website/air_splitters.htm

looks good

It also has a textured top finish in Black that goes with any colour. It is made to go with the factory spoiler.

Hot Rodders wrote:

MXHEVN wrote:"The Track Dog Racing™ Air Splitter defends your car's end against scraping and cracking. The protective splitter slides over pavement with steep approach angles while your car's flexible urethane bumper or air dam flexes -- without scratching your paint. Made from 3/16" thick, high-impact ABS plastic and built to take a surprising amount of abuse."

http://www.trackdogracing.com/website/air_splitters.htm

looks good

It also has a textured top finish in Black that goes with any colour. It is made to go with the factory spoiler.

i know, i was just quoting what is said on the website.

Thanks MXHEVIN. I just added that for those that had not been to the web site.

Hot Rodders wrote:

Looking good Hot Rodders. The Evo gold MX5 really looks so much better with some back on it.

What are the press stud around the rear parcel shelf? Are these for a canopy cover?

Yep. The car came with a full cover like the MG's used to have. I never use it because it's easier to reach back and pull the roof up.