mx5cartalk.com

Being a bit of a neat freak, I started looking at options for replacing the damaged label on the fuse box in my (NA) engine bay...



In the end, I decided to just make my own. I drew it up in Inkscape, printed, cut out, & laminated it. Then, using very thin double-sided tape of the sort used by scrapbookers I stuck it on...



Here's a side-by-side comparison, after the fact, where I realised Mazda had used gray rather than white for the graphics - but I'm happy enough with the result. The new one is smaller to allow a border for the lamination seal.



If you want to do your own, the graphic is attached (free for personal use). Just print it to an A4 sheet and it will be the right size.

That's a good repro - a while back someone was looking to replace one of their NA fuse box labels, so tks for the attachment.

Thanks for that!

Missed with the pressure wash when I first got the car and chewed up a perfect label It's annoyed me ever since - even though the rest of the car is a bit rough...

Awesome!

I would have been tempted to name the blank one "missiles " or "ejector seat" but what you have done is perfect.

Thankyou for sharing.

Like your thinking, speed. Like it so much, in fact, I've made a revised version (attached) that I may fit to my car