Wolf3d tps issue 1.8 auto
Posted: Thu Apr 18, 2013 3:36 pm
Hi,
I have a wold 3d v4 for na6. It plugs straight in to the 1.8 harness. I had it tuned at mx5 mania but the tps (variable type 4 pin connector) reads constant at 97%
David thought their was a wire to move or remove but couldnt remember. Its been tuned using map signal and runs great, but i want the tps to work as well.
I have read alot about 1.8 tps to 1.6 but cant seem to work out what i need to change to get the tps to read. Think i need to remove 1 wire to make it work but want to confirm before doing anything.
It seems this is a common question but cant get my head around it.
Someone out their knows the issue so thought id just ask.
Sorry if this has already been answered.
I have a wold 3d v4 for na6. It plugs straight in to the 1.8 harness. I had it tuned at mx5 mania but the tps (variable type 4 pin connector) reads constant at 97%
David thought their was a wire to move or remove but couldnt remember. Its been tuned using map signal and runs great, but i want the tps to work as well.
I have read alot about 1.8 tps to 1.6 but cant seem to work out what i need to change to get the tps to read. Think i need to remove 1 wire to make it work but want to confirm before doing anything.
It seems this is a common question but cant get my head around it.
Someone out their knows the issue so thought id just ask.
Sorry if this has already been answered.