Page 1 of 1

DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 1:12 am
by lonelybutterfly
HI,

My 2 door stock speakers died due to rain getting inside the door so I went and brought myself a pair of 6'1/2' pioneer splits

Image

I took out the stock speakers (5x7) and then i realised my pioneers wont fit.
So i decided to make a template on a piece of wood.

Image

Used jigsaw to cut the border.

Image

Then drew a circle in the middle using the template provide with the speakers.

Image

Jigsawed the circle.

Image

Then screwed it on the door and reconnected all the wiring.

Image

Sounds fxxking mad now, a much improvement from stock.

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 1:23 am
by Okibi
Thanks for sharing, what's that shiny stuff above the speaker? Sticky tape or part of the old plastic rain seal on the inside of the door?

Way back when I put my speakers in I was told it's best to silicon around the speaker to make it as airtight as possible. There's some audio gurus on the forum, is this still what people do?

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 1:31 am
by NitroDann
Yeah but if you havent dynamatted the door holes closed etc etc there not much point.

Dann

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 10:51 am
by frostex
Did you do anything to further waterproof your speakers so it doesnt happen again?

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 11:37 am
by lonelybutterfly
Okibi wrote:Thanks for sharing, what's that shiny stuff above the speaker? Sticky tape or part of the old plastic rain seal on the inside of the door?

Way back when I put my speakers in I was told it's best to silicon around the speaker to make it as airtight as possible. There's some audio gurus on the forum, is this still what people do?


Its plastic to zeal and cover the back of the speakers from inside.
I didnt have a silicon so i just screwed the speakers it on the wood.
It looks like a doggy job but it actually took me 4 hours to complete the job lol

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 11:44 am
by lonelybutterfly
NitroDann wrote:Yeah but if you havent dynamatted the door holes closed etc etc there not much point.

Dann


I would Dynamatte the doors if i was gonna change a whole new set up (head unit, amp, sub etc.) but all i wanted was to replace to broken speakers so i could get music playing again.

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Fri Jul 22, 2011 6:00 pm
by BadBong
Mate, you'll need to water-proof the insides of the doors on specific places to stop the rain water causing rust on the wiring (speakers are normally waterproof).

Water will always get into the compartment during heavy rain but as long as your waterproofing is good, it wouldn't do any harm.

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Sun Sep 25, 2011 3:37 am
by slimx
dynamat the ckunt!

Re: DIY: 6'1/2' door speakers for NB!!!!

Posted: Sun Sep 25, 2011 7:03 am
by Okibi
dynamat is heavy though :frown: