mx5cartalk.com

Posted: **Tue Dec 12, 2006 8:08 pm**

Hi,
Can anyone tell me if this is a simple job ?

Mine bearing is finally on the way out after making road noise for a long time. (I wasn't sure it was the bearing for a long time) I need to replace them when the parts arrive tomorrow and don't want to start the job if it's going to get beyond a fairly simple back yard job. I have done plenty of holden type wheel bearings before but have not see the sealed units on the 5's..

Thanks, Rob.

Posted: **Tue Dec 12, 2006 9:06 pm**

sorry, double post...

Posted: **Tue Dec 12, 2006 9:07 pm**

I found my answer here...
http://www.miata.net/garage/fronthub/index.html
:oops:

Posted: **Tue Dec 12, 2006 10:14 pm**

Nice .. Post ... Post again ... answer own post.

Sorry too much Rose for me

Posted: **Wed Dec 13, 2006 5:38 am**

Rob, where did you get your hubs from & how much did you pay?

Posted: **Thu Dec 14, 2006 9:51 am**

Daz 27 wrote:Rob, where did you get your hubs from & how much did you pay?

I got them through a family contact so was a 'special price'

RE Auto's in Melbourne... Best price I got at retail was $160 each from Bursons..
I saved about 20% on this in the end by going through my contact at RE...

Mazda wanted $225 each... geezz..

All fitted last night with no problems but that dust cap is a mongrel to get off..

Rob.

Posted: **Fri Dec 15, 2006 8:35 am**

Most bearing places sell new hubs...they are much cheaper than getting them from mazda.

Posted: **Fri Dec 15, 2006 5:46 pm**

I bought a SH hub from Mania. They had some NB half cuts. easy to fit and so far :roll:

no problems Cost me $65 as i recall.

mx5cartalk.com

Replacing Front Wheel bearings on NA6

Replacing Front Wheel bearings on NA6

Re:

Front hubs