disk machining - inner west sydney

16bit · Postby **16bit** » Wed May 14, 2014 4:29 pm

hey guys I am after some recommendations for disk brake machining in the inner west of sydney.

just need my fronts done.

happy for mobile recommendations too.

thanks.

Snowmotion · Postby **Snowmotion** » Wed May 14, 2014 9:42 pm

16bit wrote:hey guys I am after some recommendations for disk brake machining in the inner west of sydney.

just need my fronts done.

happy for mobile recommendations too.

thanks.

Probably not as close as want but I have used Brake Pro in Parramatta with great success.

Postby **Boyracer** » Thu May 15, 2014 8:38 am

New discs are really cheap probably not worth the trouble getting them machined.

16bit · Postby **16bit** » Thu May 15, 2014 3:02 pm

ap racing replacement rings are 200 pounds each. machining is cheap for me.

Snowmotion · Postby **Snowmotion** » Thu May 15, 2014 3:35 pm

I replaced my stock rotors with DBA 4000 and am very happy. Cost $330 v's $180 for standards.

Mr Morlock · Postby **Mr Morlock** » Thu May 15, 2014 4:00 pm

of course its worth having them machined- MX5's are not hard on brakes and its a very cheap operation- why throw out a quality rotor and buy a questionable cheap replacement- rotors are not all equal.Not worth the trouble- I drop a the rotors to my local ABS and pick them up in an hour or two or just wait if they have time to set them up. Same deal with drums. I have no idea why people think that spending $300 on rotors is a good deal. Almost all brake places will have the facility to machine the rotors and will do so provided these are not on bottom limit. PS standard rotors- last how long.