Page 1 of 1
Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 9:07 am
by lucmor444
Can anyone advise what torque settings should be on the bolts for the bracket of the PPF?
PPF.png
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 11:39 am
by plohl
104-123 Nm for the big one
36-54 Nm for the bracket.
Below is a link to the 1990 service manual. pg M-31
https://www.dropbox.com/s/68v4ag7kr6be7cx/1990_Manual_MX5.pdf?dl=0
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 12:25 pm
by NitroDann
6-8 Doogga doogas.
Dann
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 12:33 pm
by lucmor444
Thanks plohl.
All my tools are human powered at my place Dann - can you please translate '6-8 doogas doogas' into a loudness of a grunt/exhale?
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 12:57 pm
by bruce
I personally use the volume of my swearing to gauge how overtightened a bolt is.
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 1:41 pm
by StanTheMan
lucmor444 wrote:Thanks plohl.
All my tools are human powered at my place Dann - can you please translate '6-8 doogas doogas' into a loudness of a grunt/exhale?
seriously farking tight....
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 5:20 pm
by jordan.k
+1 for a couple ugga doogas with the impact, never had an issue coming loose etc, I always use a bit of antiseize on everything just for peace of mind.
Pretty sh*t job doing anything down there with hand tools
Re: Torque settings for botl on PPF
Posted: Mon Feb 05, 2018 8:57 pm
by greenMachine
NitroDann wrote:6-8 Doogga doogas.
Dann
On setting 5 only because there is no 6 ...
