Page 1 of 1

Hole in muffler

Posted: Tue Dec 10, 2013 10:45 pm
by vincevince
So my car is super low and the rsr cat back hangs rather low just at the corner of the muffler.

After a few too many scrapes, I've discovered a hole at the base.

It's spluttered some water and carbon when I was doing a check up.
After the water stopped leaking from there, I could feel small bursts of air.
Hence, confirmation that there's a hole where it's been scraping.

Should I be worried about this hole apart from a bit of corrosion?

inb4; raising height tomorrow.

Re: Hole in muffler

Posted: Tue Dec 10, 2013 10:53 pm
by hks_kansei
get it welded, should be fairly cheap.

Re: Hole in muffler

Posted: Wed Dec 11, 2013 12:05 pm
by Mr Morlock
welding is probably not likely to last long but in any event- weld or replace go to an exhaust shop and get your options.