mx5cartalk.com

Has any one made the front and rear crankshaft seal installation tools for an NB8B/C?
If so may I have the dimensions please, I cannot measure the crank etc as it, and the block, are still away getting machined and balanced.
I should be able to pick them up later in the week so I want to have the tools ready to go.
The crank locking tool dimensions would be handy too, or any ideas for other reliable methods of doing it.
Mike

google is your friend - http://www.miata.net/garage/LongNoseRepair/

Thanks for that, Google is my friend, the diagram/pic in the listed thread is busted, "Googled" and I now have the dimensions of a crank locking tool and after reading a few write ups, I don't really need anything special for the seals.
Thanks again
Mike