Hey guys having difficulty removing the conrod cap on my manley rods. Torqued them up to check for clearance with some plastigauge and now I can't budge them to check.
Didn't have too much issue with my stock rods.
I've been rocking them side to side to try to loosen them as well as some blows with a rubber mallet. No luck so far..
Any tips?
Conrod end cap removal
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
and1
- Fast Driver
- Posts: 368
- Joined: Sat Sep 18, 2010 9:43 pm
- Vehicle: NB SE
- Location: Perth, WA
-
NitroDann
- Forum sponsor
- Posts: 10280
- Joined: Thu Nov 05, 2009 12:10 pm
- Vehicle: NA6
- Location: Newcastle NSW
- Contact:
Re: Conrod end cap removal
You just have to whack them harder with your mallet.
One side, then the other.
Dann
One side, then the other.
Dann
http://www.NitroDann.com
speed wrote:If I was to do it again, I wouldn't even consider the supercharger.
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 93 guests
