Page 1 of 1
BP - Duratec bellhousing pattern
Posted: Thu Oct 18, 2012 5:38 pm
by wozzah1975
Hoping someone can answer this.
Is the bolt pattern on the Duratec and B series (BP) bellhousing-block pattern the same?
Eg: does a duratec bolt to a BP gearbox?
Cheers
Woz
Re: BP - Duratec bellhousing pattern
Posted: Thu Oct 18, 2012 6:51 pm
by sailaholic
Is the duratec the same engine as the mazda mzr?
Sent from my GT-I9100 using Tapatalk 2
Re: BP - Duratec bellhousing pattern
Posted: Thu Oct 18, 2012 6:58 pm
by mrpham
Don't know if it's the same bolt pattern, but I know that the starter motor is on the opposite side.
Re: BP - Duratec bellhousing pattern
Posted: Thu Oct 18, 2012 9:16 pm
by wozzah1975
mrpham wrote:Don't know if it's the same bolt pattern, but I know that the starter motor is on the opposite side.
Any of the hang on's don't matter, as long as it bolts up
Cheers
Woz
Re: BP - Duratec bellhousing pattern
Posted: Fri Oct 19, 2012 10:57 am
by 16bit
if you figure out how to do a duratech swap i may just pay you to do it to mine!!!!!!
Re: BP - Duratec bellhousing pattern
Posted: Fri Oct 19, 2012 11:14 am
by mx5racing
No they dont fit.
Re: BP - Duratec bellhousing pattern
Posted: Fri Oct 19, 2012 1:03 pm
by wozzah1975
mx5racing wrote:No they dont fit.
Thank you,
Cheers
Woz