Page 1 of 1
Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 12:39 pm
by 16bit
Seems there is finally a bolt on throttle body for the mx5.
http://www.good-win-racing.com/Mazda-Pe ... 164NB.htmldiscuss.
Re: Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 1:13 pm
by project.r.racing
they have one for the NA8 also. link above is for the NB8.
Re: Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 5:16 pm
by jerrah
Wow! Looks like a nice piece but is it a solution looking for a problem except for the few people who are pushing those engine limits?
Re: Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 6:02 pm
by NitroDann
No one on this forum needs one.
Dann
Re: Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 6:33 pm
by wozzah1975
Too big for any N/A appliction, and bordering too big for most turbo applications. If it flows as it should at 64mm, it would be capable of 250rwkw+, anything under that in my experience would need a smaller throttle body,
Woz
Re: Skunk2 64mm throttle body
Posted: Tue Jun 26, 2012 8:39 pm
by 16bit
this is what i thought. seems like a waist of money unless you have big power.
Re: Skunk2 64mm throttle body
Posted: Wed Jun 27, 2012 4:20 pm
by droo
the induction noise (once you've enlarged your plenum inlet) would sound *LOVELY* at WOT
Re: Skunk2 64mm throttle body
Posted: Wed Jun 27, 2012 4:42 pm
by wozzah1975
droo wrote:the induction noise (once you've enlarged your plenum inlet) would sound *LOVELY* at WOT
not as good as quads......
Woz