Page 1 of 1
REAR HUB BEARING
Posted: Fri Jun 11, 2010 10:16 am
by WASP
Hi I am about to replace the rear hub bearings, can I reuse the large locating nut's.If you have experience your advice would be welcome
Cheers
Re: REAR HUB BEARING
Posted: Fri Jun 11, 2010 11:25 am
by fattima
I wouldn't, AFAIK they are not designed to be reused. They are available from Mazda and are not expensive.
Re: REAR HUB BEARING
Posted: Fri Jun 11, 2010 12:55 pm
by Juffa
I have reused mine. Removing the nuts is not something you do often reusing them once should not be a problem.....noting that I am not an engineer, and my advise could kill you.
And I also agree with the response to your question on the big forum.
J