Page 1 of 1
Posted: Thu May 03, 2007 11:01 pm
by Boags
Never even heard of it. Is it a piggy-back?
Posted: Fri May 04, 2007 5:56 pm
by Sheck
I used to have one, its an extra injector controller.
Umm, cant remember wires fully but ther will be red: power, black: earth, green: rpm, yellow/orange: acc
Let me know if you want any other info, i might be able to scrounge around in my memories for some more!
Dave
Posted: Sat May 05, 2007 4:45 pm
by Sheck
The one i had was a two part design, had the 'brain' box and the controler. The brains had a built in map sensor so i hooked that up to a vacume. The i just fiddled with the gain and cut-in settings for the injectors.
I didnt use a rising rate fuel regulator your stock one is enough, and the stock pump is enough too. I just T-ed into the fuel feed line (not return) and the pressure will be controlled by the stocko regulator.
Not sure how the later ones worked but i'd say they all have the boost input line cause it wont activate without it.
Hope that helps!!
Dave
Posted: Tue May 08, 2007 6:30 pm
by Boags
You can run 6 psi without front mount, but you have to run so little timing advance that it isn't a very fun or drivable 6PSI (nothing off boost at all).
Posted: Wed May 09, 2007 9:02 pm
by Sheck
IC came with my kit so i was running it from the get go, 5-13psi.
Definately need an intercooler, its just silly not to have one!!!
Dave