Page 1 of 1
fixing NA6 AFM
Posted: Fri Oct 20, 2006 3:42 am
by SuperMazdaKart
stuffed up an AFM by taking out the screws, oops.. just attempting to fix it up now. no need to worry, the Mario Kart is fine & dandy. was done ages ago & found a replacement AFM fortunately
looks like all thats needed is soldering of these 3 points back onto the board, but whats this extra bit hanging off the 3rd point? wheres it meant to go?
Posted: Fri Oct 20, 2006 9:23 am
by Matty
The \"extra bit hanging off\" is what gets soldered to the arm that comes from the socket.
where the end of that arm touches the board normally stays free of solder
Posted: Fri Oct 20, 2006 1:28 pm
by SuperMazdaKart
this is the arm that it's already half attached to? & i don't actually see the point of this bit, where both ends of this bit is attached to the same arm & nothing else.
Posted: Fri Oct 20, 2006 1:41 pm
by Matty
the strip is (should be) attached to the PCB. There should be 3 such strips.
I don't know why they use two contact points but they do...
Found on the big forum:
http://www.amex101.com/rc/DSC06202.JPG
Posted: Fri Oct 20, 2006 1:50 pm
by SuperMazdaKart
oh ok, think i got it basically done then. thanks for the picture,
