Cooling issue and hesitate
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
Cooling issue and hesitate
Hi guys I'm new here I have a problem in the cooling circuit. I tried almost everything I guess. I tried the fuel and air mixture. I replaced all hoses Inc radiator waterpomp and crankshaft pully. Spark plugs and cables. The temp censors are replaced 3 pieces..... The temperature go's up and down driving normal under 60 miles no problem when the speed go's up temp go's up. Its never reaching max but go's 3\4 for 20 seconds. Than it drops and go's up directly. Please help! I'm out of ideas. Also the car hesitates under 2000 rpm) : Greetings jeroen.
-
- Speed Racer
- Posts: 7468
- Joined: Fri Feb 11, 2011 12:49 pm
- Vehicle: NA6
- Location: Purga, QLD
Re: Cooling issue and hesitate
Is the temp going up quickly or slowly?
Have the faces on the dash been changed or the dash been pulled apart? This requires the needles to be taken off and sometimes they do not go back on in the same place.
Is the undertray on?
Have you replaced the thermostat?
Have the faces on the dash been changed or the dash been pulled apart? This requires the needles to be taken off and sometimes they do not go back on in the same place.
Is the undertray on?
Have you replaced the thermostat?
-
- Fast Driver
- Posts: 222
- Joined: Mon Feb 17, 2014 8:13 pm
- Vehicle: NB SE
Re: Cooling issue and hesitate
Coolant re-route?
- MXMatt
- Fast Driver
- Posts: 137
- Joined: Mon Jun 09, 2014 9:34 am
- Vehicle: NA6
- Location: Bendigo, Victoria
Re: Cooling issue and hesitate
What about the Thermostat sticking and getting hot then releasing and dropping temp to right level?????
Might be worth a try also you have not mentioned radiator cap - has the cap and system been pressure tested??
those two little often overlooked (and cheap) items can cause a world of difference to cooling system operating temps
M@
Might be worth a try also you have not mentioned radiator cap - has the cap and system been pressure tested??
those two little often overlooked (and cheap) items can cause a world of difference to cooling system operating temps
M@
- hks_kansei
- Speed Racer
- Posts: 6154
- Joined: Tue Feb 03, 2009 10:43 am
- Vehicle: NB8A
- Location: Victoria
Re: Cooling issue and hesitate
Don't go doing coolant reroutes and stuff until you've worked out the problem, the stock system works fine in most situations.
Start cheap and work up to more expensive stuff.
Coolant - is there enough (don't just look in the overflow, check the radiator is full)
Radiator cap - replace it, they're like $10
Bleed the system - might be air in the head
Thermostat - replace it, it may be sticking, about $20
have the rad core flushed - might be clogged with sh*t, get it cleaned (try a cleaning additive, if that doesn't work, get it done properly by a radiator shop)
when buying the flush, DO NOT BUY STOP LEAK, only buy radiator flush.
The stop leak works by basically clogging stuff up, it's only of use in a dire emergency.
Start cheap and work up to more expensive stuff.
Coolant - is there enough (don't just look in the overflow, check the radiator is full)
Radiator cap - replace it, they're like $10
Bleed the system - might be air in the head
Thermostat - replace it, it may be sticking, about $20
have the rad core flushed - might be clogged with sh*t, get it cleaned (try a cleaning additive, if that doesn't work, get it done properly by a radiator shop)
when buying the flush, DO NOT BUY STOP LEAK, only buy radiator flush.
The stop leak works by basically clogging stuff up, it's only of use in a dire emergency.
1999 Mazda MX5 - 1989 Honda CT110 (for sale) - 1994 Mazda 626 wagon (GF's)
- Red Dragon
- Racing Driver
- Posts: 766
- Joined: Sun Jan 14, 2007 2:21 pm
- Vehicle: NA6
- Location: melbourne
Re: Cooling issue and hesitate
I had similar a few years ago, was the thermostat new thermostat all good
-
- Fast Driver
- Posts: 307
- Joined: Tue Jul 05, 2005 5:13 pm
- Vehicle: NA6 - Turbo
- Location: New Zealand
- Contact:
Re: Cooling issue and hesitate
the small hose that runs off the thermostat housing and returns to the water pump is there so that water flows over the t stat element. if this hose gets blocked, the t stat wont work correctly as the water flow over the element is not sufficient
red'90 vf10 turbo. FMIC,dual feed fuel rail, E Manage, "330cc" injectors.16" ADVAN RG wheels, http://www.cardomain.com/ride/264041/6
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 109 guests