Cam angle sensor failed?
Moderators: timk, Stu, zombie, Andrew, The American, Lokiel, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy
-
JBT
- Speed Racer
- Posts: 7946
- Joined: Tue Jun 03, 2003 11:00 am
- Vehicle: NC
- Location: Brisbane
Re: Cam angle sensor failed?
It will be hard to get a steady timing indication if the idle speed is fluctuating. The diagnostic box TEN and GND pins need to be bridged to set the base idle. If you can't get a steady idle then you have some other issue like a vacuum leak or fuel/air inconsistency (ICV, IAC, MAF, Intake Butterfly Seal, intake plumbing leak etc.).
-
93_Clubman
- Speed Racer
- Posts: 11856
- Joined: Mon Aug 08, 2005 11:35 pm
- Vehicle: Clubman
- Location: Melbourne
Re: Cam angle sensor failed?
mx5lover wrote:Since I replaced the engine, then my car had the idle problem. I did replace the coil pack, TB and also O2 sensor, but problem still there.
OP's idle problem:
viewtopic.php?f=29&t=53556
Which started after 1.6 for 1.6 engine swap:
viewtopic.php?f=44&t=44033&p=559478#p559478
-
mx5lover
- Fast Driver
- Posts: 113
- Joined: Wed Aug 04, 2010 8:21 pm
- Vehicle: NB SE
- Location: SYD
Re: Cam angle sensor failed?
This is the linked for my car's idle video,any one know how to post the
video here?
http://www.youtube.com/watch?v=Ldg_g-kj ... e=youtu.be
video here?
http://www.youtube.com/watch?v=Ldg_g-kj ... e=youtu.be
-
mazmad
- Racing Driver
- Posts: 1854
- Joined: Fri Jul 06, 2012 4:02 pm
- Vehicle: NC
- Location: Sydney
- Contact:
Re: Cam angle sensor failed?
Yeah you need to use the 'youtu' button above and insert into it the actual url for your vid (youtube have made it a couple more steps to get this now) As for your idle issue. No idea. 
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 2 guests
