
Engine Light is on
Moderators: timk, Stu, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy, zombie, Andrew, The American, Lokiel
- Craig
- Speed Racer
- Posts: 6701
- Joined: Wed Apr 23, 2003 11:00 am
- Vehicle: Non MX-5
- Location: Sydney
Engine Light is on
Reset the computer to clear the error code now it's fixed perhaps? 

*** Audi Q5 55 Sportback - HYBRID! Zero -100 in 5.3 seconds!
***

- Craig
- Speed Racer
- Posts: 6701
- Joined: Wed Apr 23, 2003 11:00 am
- Vehicle: Non MX-5
- Location: Sydney
Engine Light is on
*** Audi Q5 55 Sportback - HYBRID! Zero -100 in 5.3 seconds!
***

- blackster
- Racing Driver
- Posts: 782
- Joined: Wed Jun 28, 2006 2:11 am
- Vehicle: ND - 2 GT
- Location: Sydney
Engine Light is on
P0420 = Catalyst System Efficiency Below Threshold (Bank 1)
Catalyst System Efficiency Below Threshold (Bank 1)
What does that mean?
The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate. The downstream O2 sensor reading should be fairly steady. Typically the P0420 code triggers the Check Engine Light if the readings of the two sensors are similar. This is indicative of (among other things) a converter that is not working as efficiently as it should be (according to specs).
Causes
A code P0420 may mean that one or more of the following has happened:
* Leaded fuel was used where unleaded was called for
* An oxygen sensor is not reading (functioning) properly
* The engine coolant temperature sensor is not working properly
* Damaged or leaking exhaust manifold / catalytic converter / exhaust pipe
* Retarded spark timing
* The oxygen sensors in front and behind the converter are reporting too similar of readings
Possible Solutions
Some suggested steps for troubleshooting a P0420 code include:
* Check for exhaust leaks at the manifold, pipes, catalytic converter. Repair as required.
* Use a scope to diagnose the oxygen sensor operation (Tip: The oxygen sensor in front of the catalytic converter normally has a fluctuating waveform. The waveform of the sensor behind the converter should be more steady).
* Inspect the downstream heated oxygen sensor (HO2), replace if necessary
* Replace the catalytic converter
Previous
04' MX5 SE.
02' MX5 Classic ed.
04' MX5 SE.
02' MX5 Classic ed.
Return to “MX5 Engines, Transmission & Final Drive”
Who is online
Users browsing this forum: No registered users and 3 guests