Bazzar fuel pump problems

Engines, Transmissions & Final Drive questions and answers

Moderators: timk, Stu, -alex, miata, StanTheMan, greenMachine, ManiacLachy, Daffy, zombie, Andrew, The American, Lokiel

User avatar
Woo
Fast Driver
Posts: 359
Joined: Tue Oct 12, 2004 12:43 am
Vehicle: 10AE - Turbo
Location: OES Melbourne
Contact:

Bazzar fuel pump problems

Postby Woo » Tue Feb 17, 2009 11:15 pm

Well it's official ..... Walbro pumps suck (or don't as the case is)

In three years the blue car has killed 3 Walbro 255 HP pumps (GSS342). Only one warranty replacement the others have range between $120-$220
I've just brought another replacement ($160) but it'll be two days before it's here.
The most annoying part is that I have only last week finised trimming the boot, now I need to strip it all out to get the roll bar off ..... Gggrrrrr

Has anyone else had problems with Walbro pumps?

Bazz
Very slightly modified 10AE #2562 ..... one of 149 in Australia :wink:
Race what you brung ..... And hope you brung enough

Fatty
Speed Racer
Posts: 3175
Joined: Fri Feb 03, 2006 10:39 am
Vehicle: NA6
Location: Melbourne

Bazzar fuel pump problems

Postby Fatty » Tue Feb 17, 2009 11:18 pm

you might need to go to an external pump / surge tank arrangement. i mean, you're kinda going beyond what most people require outta their pumps. i dunno.

User avatar
Woo
Fast Driver
Posts: 359
Joined: Tue Oct 12, 2004 12:43 am
Vehicle: 10AE - Turbo
Location: OES Melbourne
Contact:

Bazzar fuel pump problems

Postby Woo » Tue Feb 17, 2009 11:35 pm

Thanks Fatty
I was always under the impression that a surge tank save you from lean out's from gulping in air when cornering, braking or accelerating on a part full tank.
I almost always run with at least half a tank and to be honest the pumps work great when working.

When I made the warranty claim I asked if it was caused by running dry and the Walbro agent claimed they could run dry for 20 minutes without damage. He also said the current supply may have caused the failure (to low) so I rewired with 4mm so I'm fairly sure that isn't the cause of the subsequent problems.

They just stop spinning, as if the brushes wear out :?
Very slightly modified 10AE #2562 ..... one of 149 in Australia :wink:
Race what you brung ..... And hope you brung enough

User avatar
mx52nv
Purple Porsche Eater
Posts: 1345
Joined: Tue Sep 20, 2005 5:13 am
Vehicle: Non MX-5
Location: Perth

Bazzar fuel pump problems

Postby mx52nv » Wed Feb 18, 2009 10:36 pm

Woo,
I've had my external Bosch fuel pump and surge tank set up for over 8 years now and it has never failed once. Something has to be said about the reliability of this set up. :wink:


Return to “MX5 Engines, Transmission & Final Drive”

Who is online

Users browsing this forum: No registered users and 4 guests