Page 1 of 1
Possible to remove rear badges on an NB8C?
Posted: Tue Mar 11, 2008 2:38 pm
by PASHN8
Hey guys,
Does anyone know if the 'MAZDA' and 'MX-5' rear badges on an NB8 series MX-5 bolted to the rear beaver panel with holes underneath them, or are they just stuck on using double sided adhesive tape?
Posted: Tue Mar 11, 2008 3:14 pm
by Juffa
I believe they are stuck on, no holes. If you remove the rear boot lining you should be able to confirm if there are any holes. There have been some threads on the USA forum on how to remove them....something like heating with a hair dryer to soften the glue and then cut with something thin, like fishing line.
J
Posted: Tue Mar 11, 2008 3:48 pm
by PASHN8
Will check it out, thanks Juffa!
Would like to de-badge the SE to clear up the rear end, far too busy with 3 badges on such a small rear panel!
Re:
Posted: Tue Mar 11, 2008 4:07 pm
by MasterZ
Juffa wrote:I believe they are stuck on, no holes. If you remove the rear boot lining you should be able to confirm if there are any holes. There have been some threads on the USA forum on how to remove them....something like heating with a hair dryer to soften the glue and then cut with something thin, like fishing line.
J
Dunno about the NB8 series, but i'm currently getting my NA6 completely sprayed and my badges are removed right now and i got holes on the right. See....
Posted: Tue Mar 11, 2008 4:45 pm
by Alex
yes there are holes as well, well at least in the NB8A there is
Posted: Mon Apr 14, 2008 7:46 am
by Boags
I'd want to get rid of the SE badge too... 
Posted: Mon Apr 14, 2008 3:32 pm
by Alex
