mx5cartalk.com

Hey guys

My driver side door is drooping immensely, so much so that its hitting against the striker bolt in a nasty way. What's the easiest/most effective way to fix this?

Cheers for your feedback.

Posted in the OT Lounge.
http://www.youtube.com/watch?v=BaF5JCMC-ts&eurl=http%3A%2F%2Fnews%2Ewindingroad%2Ecom%2F2007%2F06%2F

Show's you theres more than one way for making a door fit!

Not helpful.

@ the mullet.

Note to self. Next time the MX has a problem, get at it with a hammer, and wind the windows up and down lots.

Admittedly though, the rain tunnel is actually a good idea. Wouldn't mind a run through that to see where the car is leaking to fix up leaks etc.

Note to self, ignore silly comments above ^^^

Help, anyone?

has the door sagged or the bolts that hold the windoe mech. in door come loose at the bottom underside of the door?

if the door has saged considereably you will need to shim the bottom hinge(the one on the door)

this is a major task as mx door are not the easiest to hang. you will need to pull the front fender panel off as well to gain full access to the hinge

then shim as required

how many k's has the car done?

shimming doors would only be done to really high mileage cars
would first look at wether the bolt to the hinge are done up tight

that the striker plate bolts are done up tight

and that it has not been removed and re fitted lower than its original position

other things that will help short term is the guide rubber can be lifted up a little.

I always lift my doors when I shut them my sills were repainted and the thought of the them getting scratched by a dropping door is always in the back of my mind.

let us know how you go if you get the front quater panel off(not hard to do but time consuming) you will have a much better idea of the task

Grasshooper fact 637
two people adjust door much easier than one!

Thanks lowmiata!

I'll give this a try on the weekend. Will let you guys know how it goes.