Page 1 of 2
Adjusting nozzle from GB
Posted: Wed Jun 06, 2007 4:10 pm
by EGG80X
anyone know how to adjust these noozles?
Mine spray over shoots the windscreen lol....
I know with the old one you can adjust the aim of the spray with a pin or toothpick but dont know bout these ones
Posted: Wed Jun 06, 2007 4:21 pm
by Garry
Are you sure they are clipped into the bonnet properly? Mine seem to be aimed OK though I read on the miatanet thread that the NA ones shoot up a little to high.
Posted: Wed Jun 06, 2007 4:23 pm
by Boags
Yeah, Sabretooth's left nozzle was spraying over the roof to start with, turned out it wasn't clipped in the whole way.
They do spray quite high on the wndscreen though...
Boags
Posted: Wed Jun 06, 2007 4:26 pm
by EGG80X
cheers guys
*grabs the hammer, runs out screaming towards the front of the mx.....
Posted: Wed Jun 06, 2007 4:33 pm
by StanTheMan
Re:
Posted: Wed Jun 06, 2007 4:48 pm
by EGG80X
StanTheMan wrote::shock:
OMFG eggy....
its a stressfull day... need to vent out lol
Posted: Wed Jun 06, 2007 7:38 pm
by Boags
You guys crack me up.
Posted: Wed Jun 06, 2007 10:50 pm
by Ajay
arent these designed to clean the window of the car behind you?..
i fiddled with mine a bit and got them down a bit lower.. still get wet when the tops down
Re:
Posted: Thu Jun 07, 2007 12:03 am
by Babalouie
mx5_boy wrote:arent these designed to clean the window of the car behind you?..
i fiddled with mine a bit and got them down a bit lower.. still get wet when the tops down
Aren't they off a USDM Tribute or something? That's got a much taller screen than a '5
Posted: Thu Jun 07, 2007 2:17 am
by Fuzzlet
When I fit mine I'm gonna look at using a thin piece of rubber as a spacer at the front of them, to try to angle them down a little
Posted: Thu Jun 07, 2007 10:53 am
by bigdog
Mine are perfect when driving, but too high when stationary. Not a problem as I only use them when driving....
If you change the thick ness of the spacer they will either rattle around (too thin) or not fit at all (too thick). They're made to fit the panel thickness snuggly, so if you wanted to change the fit you would need to do some plastic trimming and fiddling - would be easy to stuff it up.
Posted: Thu Jun 07, 2007 1:07 pm
by Fuzzlet
In that case....bugga lol
Posted: Thu Jun 07, 2007 2:55 pm
by Babalouie
Yes but instead of reefing back on the wiper wand for a 10 second water blast, can't you just goose it to half-throttle to just get the squirt to the halfway point on the screen?
Have you guys all forgotten about throttle control?
Re:
Posted: Thu Jun 07, 2007 3:45 pm
by Benny
Babalouie wrote:Yes but instead of reefing back on the wiper wand for a 10 second water blast, can't you just goose it to half-throttle to just get the squirt to the halfway point on the screen?
Have you guys all forgotten about throttle control?
Exactly!
I usually give it a few quick pulls of the lever to get it spraying all over the wondscreen and hardly get a drop inside the car if I'm moving or stationary.
A few short sprays work better than one big, long spray.
It uses a lot less water too.
Posted: Thu Jun 07, 2007 3:46 pm
by Ajay
hahaha benny i do the same thing
ahhh great minds