fuel lid
Moderators: timk, Stu, zombie, Andrew, -alex, miata
-
Gazbo
- Fast Driver
- Posts: 244
- Joined: Fri Jul 14, 2006 8:16 pm
- Vehicle: ND - 2 GT
- Location: Sydney-ish
Re:
chatchat wrote:the base of the lid has even height, but the fuel area is uneven depth.
Just try rotating the base 180 degrees. You'll need to undo all six allen bolts of course.
Your right hand side looks to sit too high by the same amount that the left hand side sits too low.
It may not look obvious, but it worked for me. I thought I was sent the wrong type of lid until I realised the assembly error from the factory.
I packed the bottom three bolts with small washers to get the height spot on.
Daily: 2006 "C" Mazda3 SP23
Fun: 1993 NA6
Fun: 1993 NA6
-
Hammer
- Speed Racer
- Posts: 2849
- Joined: Fri Apr 25, 2003 11:00 am
- Vehicle: NB SP
- Location: Sydney
- Contact:
Re:
chatchat wrote:the base of the lid has even height, but the fuel area is uneven depth.
If its not the way the bracket is fitted to the cover ...
... have you had this car from new? If not, it could have had some panel work done and the base of the fuel area not fixed correctly.
H@mmer - 1994 Clubman | 2002 SP
GO TOPLESS!!!
GO TOPLESS!!!
-
DaleZ
Re:
Hammer wrote:chatchat wrote:the base of the lid has even height, but the fuel area is uneven depth.
If its not the way the bracket is fitted to the cover ...
... have you had this car from new? If not, it could have had some panel work done and the base of the fuel area not fixed correctly.
tested on 2 mx5.... both exactly the same.... same year, same model, same edition..... both has the same problem....
Return to “MX5 Body, Paint, Interior & Trim”
Who is online
Users browsing this forum: No registered users and 170 guests
